Barry RF gain was at max on both rigs. AF gain is fixed, non-variable, on the low-level outputs of each rig. The PRO3 had it's preamps turned off. The PRO3's output appears higher because of the extr
Mike: You'll never prove anything until you find a 50 uv source of RF, feed it into the antenna input of each rig and observe the S meter. You can ten calibrate them for S9. You will find the meter r
Beats me unless it's something to do with how the AGC responds to random noise. Wonder if the actual noise coming out of the speaker of each radio is relative to the S meter reading? I've got a sound
John: I don't think there is any problem with the PRO III's attenuation of products outside the passband. The problem seems to be the DSP producing products of it's own outside the audio passband. I
Paul The top waveform is the same thing you would see if you just hooked a scope to your speaker. It shows amplitude vs. time. The bottom display shows frequency vs. time. This is more revealing than
I promised to give an update on my experience with the PROIII so here goes: (note: I am posting this on the TenTec reflector because the Omni VI+ is compared) Here's an update on my PRO III saga. I s
The spot button is working. It produces no tone. You are supposed to push it and tune a cw signal to zero beat then let go and supposingly you'll be on the right frequency. Don't count on it! Steve N
Scott: I have a Johnson LP filter, 250-20 rated by Johnson for 1kw. It's your's if you want it. I don't know about 1500 watts but this Johnson stuff was built tough. Manual ftp://bama.sbc.edu/downloa
I hate electronic stuff with fans in them and my Astron supplies both have bothersome HUMS. I want a power supply that makes NO noise. No hum, no fan, just 20-25 amps of 13.8vdc. Any suggestions? Oh
I have the Astron 20 and Astron 50M and both of them hum. I think as they get older they tend to loosen up. Maybe I'm over sensitive to LF AF. I even bought a new PC to get away from fan noise but no
When using the Jupiter with the Pegasus Control program, the RF Gain and Squelch refuse to work but they work fine in normal radio mode. Also the spot volume wont' change when using the Peg software.
Check it with headphones. If it's loud through the headphones, try an external speaker. Both jacks are subject to not shorting properly and may need cleaning. Steve
Sell it to a sidebander and buy another one in better shape but first remove the wood screw. Steve N4LQ -- Original Message -- From: "Tony" <g3zrj@morsekey.fsnet.co.uk> To: <tentec@contesting.com> Se