Yuri, You know you are not the only one in the world that has ever operated in a contest. First, I would not think of running in a contest without using full QSK. I miss nothing this way and my equip
The same computer program can then change the semi-BK-in delay when the last character has been sent because on the Orion, everything is also adjustable in software. Carl Moreschi N4PY Franklinton, N
With firmware version 1.367, you can send CW with the Orion by simply sending characters to the Orion via the comport. My Orion control software uses this function to run a CW keyboard. Carl Moreschi
The frimware update program leaves all the old firmware versions that were previously loaded on your computer. In Bob's case, I believe version 1.367 was the first one he downloaded. Carl Moreschi N4
Press the Main/AF button on the Orion when you want to go to transmit. This will mute the receiver until you press it again to go back to receive. Just use it as a PTT. Carl Moreschi N4PY Franklinton
My N4PY Orion control program exports a tentec pegasus file interface. This allows any logging program that works with the tentec pegasus to work with the Orion. See my webpage at www.n4py.com. Carl
Mario, The AGC threshold control does not change the S meter reading. Carl Moreschi N4PY Franklinton, NC -- Original Message -- From: "Marijan Miletic, S56A" <s56a@bit.si> To: <tentec@contesting.com>
There were a few different factory values for the Omni V concerning minimum power. My Omni V was not modified from the factory in this area and it produced 5 watts at the minimum setting. I always fo
That sounds correct to me. The efficiency of my Pegasus, Jupiter, and Orion vary greatly from band to band. Carl Moreschi N4PY Franklinton, NC -- Original Message -- From: "Barbara Maloney" <ac5p@sbc
Rick, With the Omni V, Paragon, Paragon II, Omni VI, Jupiter, and Orion, there is overcurrent protection built into the radio. The radio will automatically reduce its own drive to prevent the final c
I just emailed version 1.06 of my Orion Control Program to all my Orion registered users. If you are a registered user of this software, you should now have it. 73, Carl Moreschi N4PY Franklinton, NC
Eric, You can do a lot of nice things with the Orion and my N4PY Orion Control Program but controlling two Orions at the same time from my program is not one of them. See my webapge at www.n4py.com.
Yes, you sure can. You have to rename one of them but it is easy to run two instances of the program at the same time. Carl Moreschi N4PY Franklinton, NC -- Original Message -- From: "Eric Scace K3NA
The EXT T/R percent is percent of 1 second. The QSK delay is how long it takes the receiver to come back on after transmit. Carl Moreschi N4PY Franklinton, NC -- Original Message -- From: "Mark Baile
Mark, I concur on all your comments about the rx340 AGC. I think the threshold adjustment on the Orion was added because the Orion DSP gain has a wider range, making this parameter necessary. The rx3
Version 2.13 of my software is now available. If you are a subscriber and have not received it, please send me an email. See www.n4py.com for further details. Carl Moreschi N4PY Franklinton, NC _____
But the Orion does do it with my Orion software. Carl Moreschi N4PY Franklinton, NC -- Original Message -- From: "Paul Henning" <paul@amtelco.com> To: <tentec@contesting.com> Sent: Wednesday, Februar
Add a 100 ohm resistor in series with the headphones. This will even out the headphone volume to the speaker volume. You can add this resistor right into the headphone plug from your headphones. Carl
This will allow you to set the sidetone volume so it will be the same on headphones as it is on the speaker by desensitizing the headphones. It also should work out to make the radio volume the same
I'm tired of hearing comparisons between the K2 and the Orion. The two radios are as different as night and day. The K2 only has one receiver, NO passband tuning, much less filter choices, and a very