Thanks, Carl.....always wondered. My current TenTec project involves mods to my Omni VI Plus, so I can run my SDR Play receiver as a panadapter, as well as a second receiver. Works well, but need to
The problem is exactly as you state, Jim...you DON'T see it. The female pins get permanently spread over time, exacerbated by exactly the heavy copper wire supply line you recommend. When they were N
Shuts down.....meaning:completely powers off and does not come back on at "key up"? Or....shuts down....meaning:rig stays on, all indications are that it is in TX, but no power output? Or: shuts down
Subject: Re: [TenTec] Century 21 audio hum To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>, "Josh Gibbs" <Gibbsjj@gmail.com> Date: Tuesday, May 30, 2017, 6:15 PM Tri-Flow? What is that
Gordon-I will take the Delta. Email also sent off list. Thanks-Greg, KC8HXO From: Gordon Jacobs <gordonjacobs@att.net> To: "tentec@contesting.com" <tentec@contesting.com> Sent: Wednesday, March 1, 20
Joe, et al, a big thank you for the instructions on the TenTec wiki page on how to replace the relays on the low pass filter board in the Omni VI/+! I tackled mine last weekend, and it was very easy
Don't forget the $400 KIO3B upgrade board, and the promised , but not yet yet available audio/dsp board at unknown cost. Add those, and THEN you may have 90% of a K3S. Greg, KC8HXO This (https://itun
Thanks for your opinion. I just added mine. I will stand by MY observation that the cost of the KIO3B is 18.5% of the cost of a new K3S 10 watt kit radio. That makes it a significant upgrade in my op
Only because it's easy to check-- AND overlook (Not that I have done such things......).... is the correct antenna output selected? 73- Greg, KC8HXO Hi, I have an OMNI VII issue. When I boot up the
I have one as well, and wish for nothing more at this point. It is the best $150-ish USD I have spent on radio in quite some time. Greg, KC8HXOWest Mitten Carl Moreschi N4PY 58 Hogwood Rd Louisburg,
Thanks, Barry. The link on the wiki page points to wrong website for me. I understand it should go to the PAT50 i.f. Interface board designed for 12Mhz. Great, another project for the Omni VI+ when i
I had this in my saved file..... not sure if it's current. Try: Mark Olson, KE9PQ 1490 Norfield Road Suamico, WI 54173 ke9pq@new.rr.com (920) 434 - 8097 I think he still sells on that large auction s
IMHO: The K3 DSP implementation, although modern, and although VERY adjustable, pales in comparison to the usability, and effectiveness, of the DSP in both modern Icom rigs, and my TS-590SG. I also
1. They never made an Omni V+. (RTFM)2. I concur, the TS-850S was also ergonomic for me. 3. I will suggest, if you used your KX3, for several years, and never used your K3, you would say the opposit
Us younger OT's remember it was known as the Omni V.9 Greg, KC8HXO Ten Tec made the Omni V. N4PY added a board that made it a V+. The used radio I bought had that board installed, and it added some
I would suggest watching/reading, and studying the videos and PowerPoint presentations archived at Contest University's website, paying particular attention to those by Rob, NC0B. It is time WELL spe