....Is this the model whereby one must have the switch in reverse in order to operate in USB as well?...my memory fades. Greg KC8HXO Sent from my Linux device
Subject: Re: [TenTec] TT omni vii if port problems To: tentec@contesting.com Date: Thursday, August 30, 2018, 12:59 PM Do you have any application associated with the device controlling the radio? A
Yes, but it can tune much HIGHER. Just so limiting using it as an I. F. Monitor only, in my eyes. Strokes for folks, I guess. Good luck getting it all sorted out. Greg, KC8HXO -- On Thu, 8/30/18, Bob
Fuses are cheap. I run my Omni VI Plus at about 70 Watts output, and use a 10 Ampere fuse. Occasionally it pops, butI have a good supply of replacements. Cheaper than any power supply, or breaker. Pr
A certified pre-owned Flex 6400 is $1900. With front display (6400M) is $2900. With warranty and latest software, and all updates completed. Thats far from $6000. I can remember when JUST a touch scr
Oh....on a side note, My Omni VI Plus, with an SDRPlay does almost all of the same stuff, covers much more frequency, allows 4 or 5 different software flavors, and I can operate the TenTec just like
They certainly do interact....now you know why Paul Clinton would tell folks, if it is working well, dont worry about a few 10s of cycles between friends. Greg, KC8HXO Sent from my Linux device
Subject: [TenTec] Omni VI+ To: tentec@contesting.com Date: Tuesday, April 3, 2018, 10:07 AM Good morning all, turned on my Omni VI+ this morning and I have no receive audio of rf signals. What I do h
Thanks, Martin.....glad you stumbled on the problem, whilst looking.....sometimes better to be lucky than good ;-). Greg, KC8HXO Sent from my Linux device
Subject: Re: [TenTec] Winlink and Winmoor on an Omni 6 Plus To: w7zrc@yahoo.com, tentec@contesting.com Cc: k8mp@aol.com Date: Friday, March 2, 2018, 5:38 PM Thanks Rod. I'll check it out. Later, Joe,
Subject: Re: [TenTec] Winlink and Winmoor on an Omni 6 Plus To: n4py3@earthlink.net, tentec@contesting.com Cc: k8mp@aol.com Date: Friday, March 2, 2018, 10:32 PM Oh contraire Carl. I've been keying i
http://tentecwiki.eqth.net/doku.php?id=564 Subject: [TenTec] Omni VI oscillator board adjustment? To: tentec@contesting.com Date: Monday, March 5, 2018, 1:11 PM Does anyone have the correct procedure
...and, in case folks arent aware, you need to pay attention to the delay rating when buying said breakers. Almost all have more delay than required for this application. You can find the delay curve
6V is correct. I recently purchased a pair of LED replacements, and they give a VERY even, white backlight to the meter on my Omni VI Plus. So different from the yellowish light from the incandescent
Inrad roofing filter kit for TenTec Omni V and VI series radios. New in package. 2.4Kc wide filter complete with installation instructions. $109 shipped to USA only. If you are local, I will help you