I have a few 4 wire cords, (3 insulated, one bare shield which wraps the white wire) if someone needs one. $5 each plus shipment to help out TenTec list members. They are new, high quality. The outer
FWIW, Groups.io was started in September of 2014. And it can import all of Yahoo group data. And it WORKS. And I wish every Yahoo group I am a member of would transfer there. In the long run, the mod
MikeI feel the Eagle would fit you to a Tee. Others will probably have other opinions. I will refrain from comment on any part of the current iteration of "TenTec". I felt the same about my KX3 when
BillI think the Omni C still had a high impedance mic input.... which means your dynamic Midland mic probably won't have enough output to drive the mic amplifier. One could wire it up, and try it out
You mean 229 and 238, I am guessing. Latest 2 or 3 Iterations of the 238 used a turns counter for the inductor. Last one (C) has cross needle meter. Ceramic capacitor values changed slightly from the
I have decided I can part with a couple pairs of the relays for the low pass filter board on the Onmi Vi series rigs. They are generally replaced in pairs, ass you need to remove both in a pair from
GroupHaving recently sold my Omni VI+ to a nice fellow out east, when it arrived (Carefully padded, and double boxed), the S-meter bulb doesn't work and several segments of the digital frequency read
Subject: Re: [TenTec] Cleaning Tentec switches To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Date: Sunday, January 21, 2018, 3:52 PM I had not heard a Ten-Tec recommendation against D
http://audiosystemsgroup.com/RFI-Ham.pdf The above from K9YC should be required reading on the subject, in my opinion. Hope it helps. 73- Greg,KC8HXO Sent from my Linux device
Not peddling anything. It was a suggestion for a fellow who was asking for a PTO grease available in Canada. My apologies if my suggestion ruffled feathers. Greg, KC8HXO
DentonBeen wanting to try an Orion... this seems like minimal risk. I will take it. Will email off list this evening. ThanksGreg, KC8HXO Subject: [TenTec] Ten Tec Orion 1 for sale/PT To: "Discussion
Yup....I had pondered, but not taken it further. Was thinking the digital dial would be nice for some folks that had the slide rule readout, and wanted a change. I am in your camp.....but I enjoyed r
Subject: [TenTec] Powerplug on Orion To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Cc: "Wolf Wita" <g4ssx@yahoo.co.uk> Date: Tuesday, September 12, 2017, 12:54 AM HiI have completly m
Subject: Re: [TenTec] Powerplug on Orion To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Date: Tuesday, September 12, 2017, 8:27 AM Is this the Ten-Tec Wiki page you are referring to? h