Thanks, Carl, for mentioning that.... But how do you adjust the baud rate? The TT manual in Chapter 5 says software "must be configured for a baud rate of 1200". Did you write a secret method and not
I have a new-to-me Paragon 585. The rig is slightly off frequency from its readout and the best I can do is adjust the reference oscillator with C1 to 300 Hz lower in frequency than the 84 MHz it's s
Thanks for responding you guys but I don't think you understood what I'm saying. I can't leave the reference oscillator at 84 MHz because it's not at 84 MHz! The best I can do is adjust it to 300 Hz
I never said it was, you mentioned it and the BFOs are working correctly. The reference oscillator is off frequency, hence the subject in the email. I want to fix that. This may be due to age, someo
Not all the pc boards, just replace the solder on the major and minor loop boards. Did that to mine ten years ago and it worked perfectly ever since. Pete WB2QLL
The Paragon works great on the WARC bands and 60m as well. But you do have to cut a wire jumper that I think is labeled "ham" in order to enable transmit. I don't have time to research it but it's pr
Hey Doug: Now that you mentioned this, I'm curious. Could you share details on how you built the condensor mics? Or did you take a mic out of a cassette recorder and mount it in a case? As to the res
Hi. I have an RX-320 that I've been using for some time, but don't need anymore. It works fine and is in nice clean condition. It has not been modified for DRM or anything else. Includes original whi
Maybe this will help to understand a little bit about processing: First of all, the normalize function brings the highest peak of the audio up to the maximum level specified by the user. So if you no
I've had the Ten-Tec T-Kit 1208 for the last ten years and haven't used it much the last few. Works well and looks good. Use with a 20 meter any mode transceiver adjusted to 5 watts output, or adjust
This is an exceptionally nice late model Omni C which includes the 1.8 and .5 kHz filters and all three WARC crystals for 30, 17, and 12 meters. The stock noise blanker that comes with all C's is of
Hi Curt: Yes, you recollect correctly. 17m is not it's strong point. If you look in the archives there's an extensive discussion, the best post from which I've copied below. Mine has all the WARC cry
There aren't any CVS stores in Wisconsin I could find, so feeling a bit silly about spending that much time going to the drugstore last night I drove to the Waukegan IL CVS store - 20 miles from here