I did video on rebuilding the Ten Tec PTOs. While not C22, all Ten Tec PTOs are basically the same here s the link to the video https://youtu.be/8Nvb-spxQsU 73 Mike, WB8VGE SunLight Energy Systems Th
thats what I kinda thought. Thats why, of course, it doesnt do anything on any other mode, so there is nothing wrong with the rig or the control 73 mike wb8vge The trouble with quotes on the Internet
Ohoooo.. Mike, WB8VGE SunLight Energy Systems The Heathkit Shop http://www.theheathkitshop.com/ J e e p o|||||||o A man with one clock knows what time it is. A man with two clocks is never sure.
The ten tec company along with the service department is long gone. There is NO service department and NO ten tec. Mike, WB8VGE SunLight Energy Systems The Heathkit Shop http://www.theheathkitshop.co
Hi, Andrew First, they all drift usually they settle down in a half hour or so. You didnt say how much drift Im not sure about what you mean about the RX and TX are no aligned. Do you mean as in freq
A long story short. Years ago I purchased a Jupiter with black case, blue screen, that didnt transmit. Easy fix! Right? Turned out I was wrong. I got about 2ish watts on all bands. Suspected the fina
Ten Tec did in fact change the parts in the Jupiter. They did the same for the Scout, too. Some Scouts have bipolar devices, newer ones had MOSFETs. They were very lacked in updated the manuals mike,
Snow. and the group If I recall, when you press the tune button, you only get 12ish watts out. sent mode to cw either key the rig or press the PTT on the microphone. That will give you full power. al
Ive always used a safety pin. The springy part rests agains the PTO shaft, Use one of the screws that hold the PTO to the chassis to secure the pin Mike, WB8VGE SunLight Energy Systems The Heathkit S
Hi, Rick, nice to hear from you. Hope you had a great holiday season. However. I sure wasnt looking for 311 instructions. Im not sure what a 311 is. Think you got the wrong mike 73 Mike Bryce prosola
The Omni 7 has a digital interface installed. Its not much, and all I did was plug in the cable from the back of the rig to the computers sound port. Nothing in-between. I use the vox to provide T/R
The filter upgrade helps to kill off some of the high end hiss. I did mine, but for the life of me cant say I can tell a big difference. Is there a change? Sure, but I dont know if the time/labor/mon
Whoa, thats interesting. Sounds like its going into current limiting. As the other guys have said, dig out the VOM and check the value of the current sense resistors. These are usually large sand typ
Hi, Jon, first off are you sure the Omni D youre working on has the 30 meter band? That was an option. Ditto 17 and 24 meters. I dont remember if the presets are done with diode or resistors. Ill hav
check the diodes and then transistors. The counter chip doesnt have the presets inside. Does your model have the WARC bands installed? It might have 30 meters, but its a coin toss if it has the other
Couldnt agree more ITs the control. You dont check the timing of your engine when the brakes squeal when you stop. mike, wb8vge The trouble with quotes on the Internet is that you never know if they
Another bit of info the Ten Tec 6N2 is contained in the same case as the Argonaut V. It however came with a cheap plastic main tuning knob. When Ten Tec was Ten Tec, you could order a replacement Arg