Mail Archive Search: <+from:rlcarroll@patmedia.net>

Results:

References: [ +from:rlcarroll@patmedia.net: 31 ]

Total 31 documents matching your query.

1. Re: [TenTec] AL 811 High Input SWR with OMNI V (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Mon, 16 May 2005 14:25:53 -0400; Based on experience with an AL80 I would suspect the amp is set up with the slug tuned for the phone band and may not have enough BW for a low SWR across the band. You may have to use a compromise se; /archives//html/TenTec/2005-05/msg00260.html (9,058 bytes)
2. Re: [TenTec] Popping Noise from Orion and Centurion (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sat, 9 Apr 2005 22:34:48 -0400; Tony Hopefully it's not the relay with such a new unit, but I have had two Ameritrons with open frame relays fail that way. So far I have not baked the PINs in an Alpha 86 or Alpha 89 yet, but that i; /archives//html/TenTec/2005-04/msg00216.html (10,718 bytes)
3. Re: [TenTec] Heil Studio One (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Thu, 14 Apr 2005 23:30:58 -0400; I bought my Orion with the tuner installed but did not expect to use it often and have not done so. However the few times I have used it I did not feel it did a very good job. It seemed to give up ar; /archives//html/TenTec/2005-04/msg00393.html (9,107 bytes)
4. Re: [TenTec] 1.372 stability (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sat, 12 Mar 2005 09:26:17 -0500; In my case I had exactly the opposite experience. I think my problems were compounded with RF/noise susceptibility issues when I was using 1.371, though as far as I can tell my shack is reasonably rf; /archives//html/TenTec/2005-03/msg00280.html (10,456 bytes)
5. Re: [TenTec] Orion & Tune button (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Fri, 25 Feb 2005 20:09:45 -0500; My Orion meter reads 40w out, but the RF Applications power meter sees it as 18W. Bob W2WG Got mine about a week ago. I push tune and internal meter reads about 40 W. is the again button higher load.; /archives//html/TenTec/2005-02/msg00729.html (12,365 bytes)
6. Re: [TenTec] Orion & Tune button (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Fri, 25 Feb 2005 22:26:27 -0500; In my case I have the internal tuner and get the same results as Grant. My belief is that the internal meter is not accurate at lower powers but is ok at powers close to 100w. Bob W2WG WIth or withou; /archives//html/TenTec/2005-02/msg00738.html (10,393 bytes)
7. RE: [TenTec] ORION - RF output is not stable (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sun, 2 Jan 2005 14:10:09 -0500; I spoke to TenTec about this about a month ago and what they told me is exactly what Martin suggested as the reason for the apparent variation. It's more apparent than real. Bob W2WG --Original Messa; /archives//html/TenTec/2005-01/msg00041.html (11,393 bytes)
8. RE: [TenTec] ORION - RF output is not stable (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sun, 2 Jan 2005 15:34:52 -0500; Frank TenTec did say that the actual variation was on the order of 2 watts when tuning up about 30w--so there is definitely a real component to it. I can see that on my digital meter--just depends on; /archives//html/TenTec/2005-01/msg00048.html (11,763 bytes)
9. RE: [TenTec] New roofing filter in Omni VI- Opt. 1 (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Wed, 12 Jan 2005 14:47:57 -0500; I use a low offset. Bob W2WG Bill: I wonder how many do use an offset that low? John N1JM Hz, and works fine with the slightly different offset (600 Hz) of the 753. I suspect that Inrad chose 700 Hz; /archives//html/TenTec/2005-01/msg00397.html (10,517 bytes)
10. RE: [TenTec] Orion mic preamp question. (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Wed, 12 Jan 2005 15:06:53 -0500; JohnI have an MD2 and am interested in your results. Let me know how the preamp works out. Bob W2WG I wish to use my Yaesu MD-1 dynamic mic with my Orion, however the output at 5mv is too low. The Or; /archives//html/TenTec/2005-01/msg00404.html (9,574 bytes)
11. [TenTec] Orion AGC Setup and Audio Spectrum Analyzers (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sun, 16 Jan 2005 08:20:38 -0500; At one of the sites discussing optimum setup of the Orion AGC for various band conditions I saw a recommendation of taking a look at the audio out using a software spectrum analyzer. A couple were re; /archives//html/TenTec/2005-01/msg00611.html (8,084 bytes)
12. RE: [TenTec] Orion AGC Setup and Audio Spectrum Analyzers (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sun, 16 Jan 2005 16:59:37 -0500; Thanks for the tip! Free is good. Bob W2WG Bob, Check this one out. It's freeware. 73, Chas At 08:20 AM 1/16/2005, you wrote: Alas, _______________________________________________ TenTec mailing list; /archives//html/TenTec/2005-01/msg00645.html (9,121 bytes)
13. RE: [TenTec] Orion reset (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Tue, 18 Jan 2005 18:09:28 -0500; John I had the same experience. I loved the rx but found it decided to freeze every few hours of heavy use and if I left it on long enough it would do the same without transmitting. I simply could no; /archives//html/TenTec/2005-01/msg00763.html (13,118 bytes)
14. [TenTec] Noisy RX (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Wed, 19 Jan 2005 12:06:50 -0500; I can't help wondering if some who are finding the Orion a noisy receiver might not be used to listening to radios with AGC set up quite a bit differently. I normally run with no hang time and a fast; /archives//html/TenTec/2005-01/msg00796.html (7,197 bytes)
15. [TenTec] RE: [Orion] 500Hz & 250 Hz Center Frequency Adjustment (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Thu, 20 Jan 2005 10:03:43 -0500; I had trouble finding a steady carrier without fading on long enough to make the adjustment. Rather than lugging up a signal generator I used a second rig at minimum power feeding into a dummy load.; /archives//html/TenTec/2005-01/msg00829.html (9,663 bytes)
16. [TenTec] K5SF Orion Dongle (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sat, 22 Jan 2005 13:01:13 -0500; I just received an Orion dongle from Rich, K5SF. It works very well, giving access to all the signals at the Orion Aux I/O Port. I had been edging up to trying to make a cable which would provide all; /archives//html/TenTec/2005-01/msg00884.html (7,423 bytes)
17. [TenTec] Orion AUX out audio question (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sat, 22 Jan 2005 18:05:59 -0500; The Orion supplies left and right audio out through the aux DIN connector on the back. They are "line level." Is the signal out independent of the setting of the volume control? Bob W2WG; /archives//html/TenTec/2005-01/msg00887.html (8,037 bytes)
18. RE: [TenTec] Orion AUX out audio question (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sun, 23 Jan 2005 08:51:49 -0500; Thanks to all for the info. I was hoping the individual receivers had fixed line out but I guess the "exotic" arrangement is workable. I was used to the independent fixed line-level outputs of the FT; /archives//html/TenTec/2005-01/msg00904.html (11,477 bytes)
19. RE: [TenTec] Orion AUX out audio question (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sun, 23 Jan 2005 09:38:42 -0500; Martin I would like to see line out as you described your wishes. Bob W2WG Tommy, My rig does not behave that way. Left=Sub produces constant output unless you zero out the Sub AF volume. (v 1.372) I; /archives//html/TenTec/2005-01/msg00907.html (9,878 bytes)
20. [TenTec] Spectrogram (score: 1): Author: "Robert Carroll" <rlcarroll@patmedia.net>; Date: Sun, 23 Jan 2005 15:56:36 -0500; I have been playing with Spectrogram and looking at the audio output of the Orion, particularly at how the various AGC settings allow or suppress the inter-element noise depending on the decay time s; /archives//html/TenTec/2005-01/msg00919.html (7,789 bytes)

Current List: 1 - 20
Page: [1] [2]