Hi Greg and list - I think I owe you an apology for "jumping the gun" Greg. I knew I should have kept my mouth shut! I do apologize and am glad you were nice enough to post the comments below. Thanks
As a new comer to Ham radio I want to comment on Hyder's comments about me as copied below from the reflector - which are quite insulting. To answer his question: I care about specs because I am curi
For those of you who use HF only rigs but would like SWL abilities etc I would like to share that my experiences with the little Rx320D computer controlled rig are pretty incredible. Carl, N4PY, sugg
Hi folks - I've determined that the 1.8 slot on my PTB board has no voltage coming through the three pin connector 41 on the rear left corner of the board. When the 250 and 500Hz filters are engaged
Tom - You da' man! I say again, YOU DA' MAN!!. You helped this dimwitted idiot fix it and NO shipping to Ten Tec. Man am I jazzed!!!!!!!! After I read your email I started tracing the voltage backwar
Between you two guys I fixed it!!!! For a non-electrical engineer this feels like nuclear science and a small tracing like this is a HUGE success! Thanks Ed and Tom!!!!!!!!!!! You guys are GREAT!!! -
Jim - There was nothing written on your reply. Did you want one of the Airpax breakers? Regards, Tim -- Original Message -- From: "Jim Lowman" <jmlowman@ix.netcom.com> To: <tentec@contesting.com> Sen
OK, Ron - I'll reserve one for you until you let me know if you want two. BTW the breakers are not small - the last one I got I mounted in a small box and then put it in the power cable. I'll order o
Hi folks - Looks like John Graves and Ron KI0II will get the extra two breakers. I'll let you know how much they are and get checks after I order. Thanks everyone. Ron - can you email me your mailing
Hi folks - Been fooling around abit with the above mixer. Seems pretty great for receive but sure distorts/ruins cw sending. I'm assuming the terrible sound of my cw sig is from RFI - in which case I
Bob - I think I mislead you. My external speaker is connected to the HEADphones jack - thus it does not need an amplifier and gives excellent volume and ability to control via the mixer. The Omni's e
Hi Ken - I suspect that's what is happening, but last time I started playing with with chokes for RFI it drove me crazy - suppose that's why I'm not reall motivated to go on the "Choke Chase" heh heh
Since the Argo is being discussed I will share my non-lab experinces. I traded my Corsair II in on one. I sent the Argo back in less than a week and thanked God the Corsair II had not been sold (righ
Hi Jan - I recently acquired an Omni VI+ (love it) and I installed the 500 and 250 filters on the 9 MHz board. I work 99% cw and I am pleased with this arrangement. However many ops elect to put a 1.
Hi folks - I'm not an audio nut and really don't want to fool with the mixer I got recently. It's new in the box - if anybody wants to buy or trade let me know - just want it to get used by somebody.
Hi folks - I had a number of responses about the 602 mixer - which suggests to me that I need to create a firm price to avoid confusion. So let's try this: It is brand new and cost me $59 plus shippi
Hi folks - To all who raced to send an email back, I thank you. The mixer was sold based on the time of the first email. Thanks very much folks. Regards, Tim NZ7C
Hi all - After literally going through a spasm of entire shack equipment/rig turnover in the last few months I heartily agree with John's comments. For the record, after my "shack pverhall spasm" the