I also just purchased an Argo 5 and it is a great little cw rig. I have tried to get it on SSB but the mikes I have on hand don't sound very good.....real high pitched and tinny. I have tired the TT
I have been using the 705 mike but I get reports of high pitched audio. I think the 706 is a bassier mike from what I have heard, and I may try one of those. Someone said the carrier osc. might need
Larry, I get the sense that it will not be much longer before 2.0 is released, but believe it could take another several weeks....maybe into next year in January. The probelm with making or setting a
You are exactly correct. There are two versions of 2.0 as there were two many problems trying to use the same code for both rigs, but this is old news as we found out about this in early to mid Octob
Don, Hold user 2 in while turning the power on and this will put you into the firmware update mode, and then reload the firmware that you were using. This may be the only way to unlock the rig. Toby
NO! User 2 is the way to get into the update mode when the rig is locked up. I have recently had this happen to me twice and nothing worked but reloading the firmware by using the User 2 button. Reca
Yes, including the red tx led and a blank screen. Using user 2 would be worth a try if you havn't tried it. Be prepared to reload the firmware however. Toby W4CAK lights
Sorry to hear that Don. Hey, Just for grins....try the VFOB Lock button and do the Ram Clear again. Maybe you have changed things by attempting the user 2 update mode. Good luck in getting the proble
I agree, I would prefer the S meter to work like it does in 1.372. The other way you really can't tell what the received signal is unless the RF gain is turned mostly all the way up, this is one feat
When I install version 1.367 which is my favorite version I have to uncheck "stop on errors" or it will not load properly. I like this version because the sweep work really well and the firmware is v
Could you have norton anti virus running in the back ground. I would get a very slow load a few lines at a time when Norton was running in the background....check this out. Toby W4CAK -- --
Ron, Do you notice any loss of signal audio when turning the BW encoder from 200hz to 100hz in the cw mode? Not the signal strength but the audio itself. I seemed to notice loss of audio the last tim
I suppose you guys have done a ram clear and master reset? This cleared the problem up for one BETA tester. I am also in contact with another ham who has reported this problem and suggested the ram c