*Don't know about the High Class Operator part ! I can however testify to the times that I didn't switch over to Dummy Load and worry like a Mad Man because a Thunderstorm came from nowhere while I w
*Several years ago upon moving my stuff in with my Beautiful Brenda, ( now a General Class KK4CJG ).... I had no permission ( at the time ) from our Landlord to put up an HF Antenna. After a bit of l
*Great call about the AM Radio Mike. I also use them to test Remote Controls, Switched Mode Power Supplies and to track down Bad Transformers on Power Poles. Just hold your TV Remote close to a Porta
*I have never done that but, can't see any problems with doing the mod. It could decrease the resale value by not being original. Just remember the Ten Tec Protection Circuit. As you probably already
*Hello Ron,* * I am pretty sure that you are looking for a PJ-068 microphone jack. There is at least one, Somewhere !! in a junk box here at the shack. My Drake T4 Transmitter and lots of Drake Radio
*The Filter Board has relays which as the name suggests, switches different filters in and out of the Transmitter Circuit, depending upon which band you have selected. When this happens to your radio
*Hello Again Vic,* * Since nobody else has jumped in to comment further. If your problem is only happening between 6.5 and 10.5 Mhz. It is my belief that on the Low Pass Filter board of your Paragon
Good call on the bad jumper Jim. Looks like we were both typing a message at the same time. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.cont
*And that is why Paul Clinton is my HERO. I never thought to look for the simple. Just jumped to something Bad and Harder to fix.. Thanks again to Paul.............* * Wade/KJ4WS* ___________________
* Thanks for the Posts and Friendship that we have found in this forum throughout the year. We Pray that 2013 will be the best year ever for you and your family. Merry Christmas and Happy New Year to
Wow, Mike is that a set of Drake Twins I see on one of the shelves? If you only knew how much I miss my T-4C R-4C Twins, you would not have let me see that particular picture. Oh well, at least it wa
*Before listing my Model 234 Speech Processor on FleaBay, I thought that someone at this group may want to make an offer. What do they sell for on average used? This one is about a 6 of 10 in looks b
If the Pass transistors are getting hot, I would suggest you check across the positive and negative output leads with the supply unplugged. If you see Zero Ohms or a Short then it is probably the Cro
*Hello John,* * I had thought to send an Email on Monday to say how sorry I was to have missed both nets. With both arms buried elbow deep in an old National NCX-5 ( 60's model boat anchor ) the time
*My antenna has been the same for 35 years. 63 feet of # 12 wire times 2. That's 126 feet of wire and fed with 450 ohm Stranded Ladder Line. We have virtually the same feed system. I use a home wound
Personally, I don't give a rats pa-toot if Ten-Tec ever shows up at a Hamfest . They make a Great Product Line which works well and their Support has no equal. If, I had the money ... they would send
Double AW! I believe that you are 100% correct. That Blazing Orange Ball between the T's makes all the difference in the world. If I ever get to purchase a .. NEW .. Ten Tec Rig, it is my hope that I
*Good Morning to all on the reflector. I try not to post stuff that is OT but, this deal is just too good for me NOT to tell folks about. At the link below, you will find 4.5-30 Volt Blue Display Dig
*Having called the Tennessee Section ARRL Phone Net at 3980Khz for about 3 years and Not Missing as Net Control for over a year and a half on Wednesday Nights. I could tell some interesting stories.
Are some of the Heil Headsets and Microphones still using Hot Glue to hold the Elements in place? When I saw this in a rather expensive Headset, I was amazed that this could be. For the price, a coup