Following on from my two previous posts, I had been experiencing the start up issues for a few days and was going to get on with the A9 recap very soon. However, when the rig was booting up this morn
Hello Petr I have just found your several postings regarding your Omni V. They had all gone into the spam folder on the server of my email provider which I check from time to time. It also intercepts
I am just getting to grips with a new Omni VI Plus that I have very recently acquired. It is in almost as new condition and generally works very well. I decided to listen to the Omni's keying on my T
I have just read all the information on the Ten Tec Wiki which answers all my questions and more and confirms that my assumptions are correct. It also solves a previous post I made by way of a simple
Hi Dennis It is undoubtedly the battery that needs replacing. I had a friend's 566 to sort out and that did exactly the same but was fixed when I replaced the battery. Go to the Ten Tec Wiki, then to
After a two year search, I have finally acquired a very nice Omni Vl Plus. I would like to know if anyone has designed/undertaken a modification to eliminate the slow noisy amplifier relay to allow s
I posted the message below some weeks ago. Not having had a response, I am repeating it again below with a few additional comments. My Omni VI Option 3 has a problem on SSB transmit whereby there is
Good morning John, Bob and Gary Thank you very much for all your suggestions in relation to the problems I am experiencing with my Omni Vl. I did buy it to upgrade and play with but I had not expecte
I am looking for a replacement Low Level Driver/NB Board for my Omni Vl Option 3. My noise blanker does not work at all but otherwise the rig is now fine. The board number per the manual is 81608. An
Hi Petr Do you really want 3.033xd or 3.033xe ? I have both and use 3.033xe. I also have 3.029 which is very good. How is the O2 ? Barry VK2BJ On Tue, 13 Aug 2019 at 18:55, Petr Ourednik <indians@xsm
My Omni VI Option 3 has developed a problem on SSB transmit whereby there is a permanent tone/carrier of about 1.2kHz above the actual frequency and within the audio passband. It was first brought to
Hi John Are you sure that COM 3 is actually the one connected to your O2 ? Does your old XP laptop have a serial port ? If so I would be using a serial cable direct from the laptop to the O2. Have yo
OK John It's years since I had anything with XP on it so I can't remember how things work. However, if it's similar to current versions ie W10, you can check your computer com ports by right clicking
Hi Gary I would like one of the main tuning knobs for the Omni VI please. Please let me know how much including postage to Sydney, Australia. My address is correct on my QRZ page. 73 Barry Simpson VK
I have recently acquired an Omni VI Option 3 which is working but needs some TLC to bring it up to par both physically and electronically. One thing I need to do is to correct the frequency calibrati
Hi Allan To enable me to make some suggestions, please can you provide some more information on your set up please: Computer O/S - W10 ? Type of serial to USB convertor ? - I assume that you are usin