Who are some recommended repair service providers for TenTec amplifiers ( such as the Centurion amplifier?) Thanks. --From: "Mike Bryce" The ten tec company along with the service department is long
My 238C antenna switch has seemingly gone bonkers. I connect one coax(antenna) to any of the four antenna connectors on the rear of the unit and when I switch from antenna 1 to 2 to 3 to 4, I get the
What you describe sure sounds like a relay problem to me. Although I dont have a Hercules II amp, I do have the same problem with my 20m 2-el vertical phased array. When I go to rx, sigs are sometime
This may or may not help, but here's my story. My 23 yo Centurion worked like a charm for 5 years after I bought it used, 10 yrs ago. Then one day the grid started going negative. I had a local tech
My Vectronics DL2500 fan cooled DL seems very stable when tuning up on 160-6m. What kind of dummy load? An off the wall idea, but when the "dummy load gets very warm", is it still 50 ohms - or is the
1. I periodically hear an occasional soft "tick" coming from the amplifier during a key down tune up procedure in my Centurion. Assume theyre due to to gas build up in the tunes, discharging? Any ide
I recommend Malcolm Technical Support - Scott Malcolm - Toledo, WA - (ICOM & Kenwood Service) mts@toledotel.com Used Scott a couple years ago on my balky TS-50 with multiple problems that nobody want
Bought this used from an estate sale in 2014. Worked great for 3 yrs. Then a tube short blew a fuse. Replaced both finals and all was well until a few months ago. The amp worked well for a few transm
Thanks for the suggestions guys. Looking like its a tube issue. I will pass that along to the tech wrking on the amp and see what he finds. Bob Sent from Mail for Windows 10