I use a ten tec 20 in 6m out runs 8watts I get a lot of contacts when band open. Greetings: I'm new to the reflector and also to Orion II. I am currently keeping my FT-950 for use on 6 Meters but I q
I think it is the same as the 307 speaker Suggest you look in your supply at the speaker and take its measurements. Then I'd go to that Jameco site and find one that fits. You can go other places, pe
I agree 709a great mike for the money. The 709A is a better sounding mike. 73 Bob, K4TAX Looking for suggestions on a mic for my OMNI V. Leaning toward a 708 desk mic. I used one on a Paragon II at o
Best is to use a switch to switch between radios and listen for more than a few seconds. I did a little bit of A/B/C testing on 160M with my Omni VII, Peg's Eagle, and my Corsair II. I am not happy w
you don't half to, TENTEC HAS A GREAT MIKE A709 FOR 69.00 Anybody have a Ten Tec mic they'd be willing to part with cheaply? It could even be one of the old Ten Tec hand mics you might have setting a
yes I did work ok ROD Has anyone installed the $15 INRAD receive audio modification? Results? Opinions? Paul K0UYA _______________________________________________ TenTec mailing list TenTec@contestin
I have a gray face I took if off and put on black face so I can have both. I think that the black looks best. I sense from the words "grey faced Ten Tec amp" that he's a collector who cares more abou
I did the download now s meter does not work. Just posted an update on the TenTec web page for the Orion II Model 566. Version 3.033xa December 20, 2012 Added S-Meter Calibration The procedure is dow
I got the s meter to work as per instructions I did not like the agc. Just posted an update on the TenTec web page for the Orion II Model 566. Version 3.033xa December 20, 2012 Added S-Meter Calibrat
ssb on 30 t0 40 db signals no nb or nl on bw ay 3000 Distorted how? SSB and/or CW? Can you describe the distortion? It is distorted through headphones? Distorted through speaker? What are the PBT and
I found that the trouble I was listing to to many ts 590 2 on 40m ,1 on160m they were distorted I check my orion with hams I new and they were sounded good. If you are getting distortion on strong ss
it is the capacitors on the regulator board this is the small board on the bottom of the orion --Original Message-- From: Peter Frenning [OZ1PIF] Sent: Friday, December 28, 2012 2:45 PM To: Discussio
just send the board in to ten tec for capacitor replacement it is very small so easy to ship. 73 Rod --Original Message-- From: Peter Frenning [OZ1PIF] Sent: Friday, December 28, 2012 2:45 PM To: Dis
For sale a Jupiter with tuner,hand mike, fan kit,cw read and keyboad trams,manual.power cord Jupiter is in very good condition 9/10 825.oo 825.oo shipped.
Get a 709 mike and do a a/b test. Just a few comments: 1. I only use 3900hz tx BW when I'm on AM. It might be worth checking whether you are actually gaining any tx fidelity in SSB by increasing from
I did 3 resets now ok got am fm now. when you update to the new chip for cw do you lose am and fm I did. _______________________________________________ TenTec mailing list TenTec@contesting.com http
Use one from the Centurion --Original Message-- From: Rich Hallman - N7TR Sent: Monday, October 29, 2012 10:15 PM To: Discussion of Ten-Tec Equipment Cc: Discussion of Ten-Tec Equipment Subject: Re: