Ken Brown wrote: Omni-A. I did the CW mod as suggested by Steve N4LQ and the improvement was remarkable. What does this mod do? Is it a mod to an audio or RF stage? What is the problem without the mo
Paul Gates, KD3JF wrote: I have the WMR cable and cd with the drivers. Alot of the cables sold will work if you have the needed drivers for it to work. If you get the WMR one be sure you install the
Argonaut 509 w/CW filter and manual. In very good condition,works well.I converted 10 meters to 30 meters, easily reversed if so desired. Smooth PTO and no known problems. $250 OBO Ed W3NR
jcharley@bellsouth.net wrote: Has anyone tried Steve's Audio Mod for the Omni C? What do you think? I did his AGC Mod for the Omni C and it works great. I sometimes have to have the RF and AF gain at
1) Any chance a list member has one for sale? Any chance list members know where I might get one at this late date? 2) Would also like recommendations/advice regarding exactly what filters I should
Argonaut 509 w/CW filter and manual. In very good condition,works well.I converted 10 meters to 30 meters, easily reversed if so desired. No other mods. Smooth PTO and no known problems. $250 OBO Ed
Argonaut 509 w/CW filter and manual. In very good condition,works well.I converted 10 meters to 30 meters, easily reversed if so desired. No other mods. Smooth PTO and no known problems. $250 OBO Ed
Argonaut 509 w/CW filter and manual. In very good condition,works well.I converted 10 meters to 30 meters, easily reversed if so desired. No other mods. Smooth PTO and no known problems. $250 OBO Ed
Looks great, but I quickly found that the dial is way off. It will not go the last inch to the left, and goes correspondingly too far to the right over the meter. Way too far for the adjustment wheel
I took my Omni 6+ down for repair and the turnaround time was really good for this older rig. The rig is fixed and the charges were fair. I believe that the success of Ten Tec to a great extent is a
I am receiving a pulsating tone that is rather wide around 3.860 MHz. It sounds just like the calibrator signal on an analog Triton IV, however there is no calibrator in the digital version as far a
Argonaut 509 w/CW filter and manual. In very good condition,works well.I converted 10 meters to 30 meters, easily reversed if so desired. Smoth PTO and no known problems. $250 OBO Ed W3NR
I have the 525D and need to see if I can find the correct info on curing the AGC "pop". So far, the candidates are C28 C30 and C40. C28 seems more reasonable, but can anyone tell me for sure. I've al
Mike, thanks for the info. I had already checked the websites. I was looking for some user input. I need to knock down the 20 and 30 over signals on 40/80. And the AGC "pop" is murder on the ears. Ed
73's Jim K1QCF Because the speaker is located in the front of the power supply. I have two of them on my desk, to the right of the Omni VI Plus and to the right of the Paragon II. No humm. 73 Bob, K4
Keith, I use my VI on RTTY (FSK) and PSK31 (AFSK). I called TT when I first tried to set up FSK, I could not get it to work correctly. I later found that it was due to some bad advice. Here is my cur
Robert Redmon wrote: Am looking at an Omni 6 that the owner claims to be a factory option 3, but based on the picture he sent, the key pad is identical to a standard Omni 6. I understand that part of