Send me a join-up form, I have some old Ten Tec radios and one 66 of the new line. I need a Symptom verses cause, Its the 565 and 566 ...... ________________________________ From: TenTec <tentec-boun
This a persistent problem and very sensitive to volume Levels First try was the Power Regulator Board, replaced the board and monitored the +5 and + 13 VDC wit a scope and DVM . No Sags or response o
Yes the board looks different I did not know if the signal levels are the same. Receiver A and B to main Audio amplifier and speaker driver??? I will look at the website again thank you. Sent from Ma
WILL THEY WORK ON ORION 1 & 2 POWER DIST BOARDS??? IF NOT WHO??? Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 Hi As my Christmas present, my husband drove me over to
Please send me a Invoice, with our preferred payment method, I can do Pay Pal or Credit card? I have replaced one with a DC to DC for the 5 volts unit and a 11 Volt DC to 24 VDC 250 wat unit, very bi
Do you have the Orion A9 Power Controller Board, good or bad I need to build my own and ue he board for he plug-in??? ( Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 T
Thank you, how do I pay you I have pay pal or just send you a bank certified check to your call sign address? Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 I have a co
Thank you guys, I bypassed the Molex connector and the 565 was back to normal. Wired the 566 unit directly to the I/O backplane board and the occasional problem with driving its SGC500 also went away
Hello guys this is an intermittent, if you power it down for a while it come back on ok. Cant tell if it is sourced by one of the receivers or the other since volume control has no effect on the soun
The Transceiver Went dark while receiving band activity No S meter Lamp No Led illuminated No Display Light No TX No Rx A very low sound when he power switch is set to on Main Power Fuse is good 566
Thank you Bob, I did not like the reports I got from the Centurion driven by the Johnson Viking. I got better reports with the Johnson with the 60 watt carrier, I did not calculate AM or had a readou
I have two, one of which has a fan speed control used to speed the fan for am operations with drive power set at 60 watts. When used on SSB the fan is slowed t very quite and drive run at 100 watts.
I have two(2) Ten-Tec ORION Radios and I was off the air for over a year after major flooding in South Louisians. I have problems with the Multi Knob Power level mic gain and other functions don't ca
I am holding out for the next HFRig, I have had several holding on the Orion 2. They RX Very well, Tx audio Broadcast Quality on SSB. I am 68, they need to hurry-up. Amos 2 Sent from my iPad
I have done both on both of the radios and the pay out is worth it. Lots of work space and a work light if you are a 1947 model ham, like I am. Amos 2 Sent from my iPad
Thank you for the effort and presence, I now have three (3) of the little handy-talkies. I am enjoying them and they allow communications around the estate between my wife and I. Getting a channel pl
I would not remove it, ware indicates active use not a shelf ornament. I have a transmitter and receiver that I bought as soon as I could afford it. The frequency dials and all controls have the same
When it pops, your smoke is leaking out, the fan is blowing it out the side, you want to keep all of your smoke in. Turn it off, let the HV supply bleed down. Remove the cover, lots of screws, save t