Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TenTec\]\s+Delta\s+II\s+intermittent\s+RX\s+$VCO\s+issue\?$\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TenTec\]\s+Delta\s+II\s+intermittent\s+RX\s+$VCO\s+issue\?$\s*$/: 5 ]

Total 5 documents matching your query.

1. [TenTec] Delta II intermittent RX (VCO issue?) (score: 1): Author: Al Gulseth <wb5jnc@centurytel.net>; Date: Sat, 12 Dec 2015 18:56:41 -0600; My recently acquired (from an estate) Delta II/536 exibits intermittent operation on the 14.5 - 21.5 MHz range (VCO 3) and has also gone dead once briefly on the < 7.5 MHz range (VCO 1.) The SK's son; /archives//html/TenTec/2015-12/msg00294.html (7,894 bytes)
2. Re: [TenTec] Delta II intermittent RX (VCO issue?) (score: 1): Author: "Steve" <wa9jml@frontier.com>; Date: Sun, 13 Dec 2015 01:05:10 +0000; My Argonaut II had VCO problems similar to what you describe. I sent it in to Ten Tec Service and it has worked fine ever since. I don't remember what the did to fix it. Steve WA9JML Sent from my Ver; /archives//html/TenTec/2015-12/msg00295.html (9,119 bytes)
3. Re: [TenTec] Delta II intermittent RX (VCO issue?) (score: 1): Author: <km2km@twc.com>; Date: Sat, 12 Dec 2015 20:26:27 -0500; A few years into using my Delta II the same issues popped up. and I sent it back to TenTec. They said that in the original runs there were soldering issues on the VCOs. The one that was a problem for; /archives//html/TenTec/2015-12/msg00296.html (9,470 bytes)
4. Re: [TenTec] Delta II intermittent RX (VCO issue?) (score: 1): Author: Mike Bryce <prosolar@sssnet.com>; Date: Sat, 12 Dec 2015 21:43:11 -0500; The solder on the VCO isn't the best. The fix is simple. I had to do this repair I On several delta IIs. Remove the pcb, it's under the sun chassis There are three VCOs. I usually work on all three.; /archives//html/TenTec/2015-12/msg00297.html (11,526 bytes)
5. [TenTec] Delta II intermittent RX (VCO issue?) (score: 1): Author: "Mark Kenward" <k8vf_mark@centurytel.net>; Date: Sat, 12 Dec 2015 21:50:56 -0500; Before you do anything else, check solder joints in vco 3 area on VCO board.....you will surely see some bad joints, or contaminated joints. Re solder anything in that are looking dull, or contaminat; /archives//html/TenTec/2015-12/msg00298.html (7,184 bytes)

Current List: 1 - 5
Page: [1]