25 watts?? For a mode that only needs minimal wattage?? Try less and be amazed. (the spectrum would also be cleaner if we all did) (smile) Ron "the 516 is a keeper" __________________________________
A comment to the point of setting vs. controlling the power on the Jupiter. For modes like PSK-31 the Jupiter should be configured to operate at its rated output power or 100 watts. Then the actual p
Hello, I subscribe to this list for this reason : What is the adjustement for PSK31 using a Ten tec jupiter. I am agree with you that ALC indicator should not be always lighted. So I adjust sound car
Hello Herve In psk, "DO NOT BLINK THE LIGHT" period Carry-on Bill Harris w7kxb -- Original Message -- From: F8EHJ<mailto:f8ehj@free.fr> To: Discussion of Ten-Tec Equipment<mailto:tentec@contesting.co
Agreed. If the ALC light blinks either you have too much mic gain or too much signal from the sound card. There should be NO ALC action for a good clean PSK-31 signal. With Tentec radios, when proper
A comment to the point of setting vs. controlling the power on the Jupiter. For modes like PSK-31 the Jupiter should be configured to operate at its rated output power or 100 watts. <SNIP> This is ba
Hello group, Thank you Bob/K4TAX. You said what I was trying to say in both of your recent emails. Someone on the waterfall told me how to adjust my system, and then gave me a report. I too watch the
OK, thanks, We must light ALC LED and what about MIC GAIN ? If I want reduce OUTPUT RF POWER, do I must reduce MIC GAIN ? 73's herve F8EHJ Le 2 févr. 08 à 18:41, Bob McGraw - K4TAX a &e
I am always amazed at how effectively very weak PSK transmissions are decoded by the software. I attribute this in part to the very narrow signal bandwidth, which as you all know, concentrates the po
You are most welcome. Glad to be of assistance. 73 Bob, K4TAX _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/te
First let me say, "if it isn't a microphone it should not be connected to the microphone input". Of course it can be done but one has to be very careful with the method they get the soundcard level {
Correction - we must NOT light the ALC LED with PSK-31 signal. As to reducing output power, either reduce mic gain or reduce sound card output. 73 Bob, K4TAX OK, thanks, We must light ALC LED and wha