I own a T-T Model 416 Titan II Amp and having a problem. It started with an burning arc located at the bottom of the 160 / 80 Meter coil at the junction of the 1/4 inch tubing coil. It carboned the b
I would call Mouser/ or look online..Randy I own a T-T Model 416 Titan II Amp and having a problem. It started with an burning arc located at the bottom of the 160 / 80 Meter coil at the junction of
Bob, the manual gives no info on type of cap, voltage rating, dimensions, etc. I'd think you really need to provide that info in order to find suitable replacement parts. 73, Barry N1EU _____________
I would start at RF parts... They normally keep a decent supply... Cecil K5DL Sent from my iPad ap _______________________________________________ TenTec mailing list TenTec@contesting.com http://lis
Bob and others On pg 43 of the latest RF Parts catalog, there are 300 PF\7.5KV caps for less than 20 bucks. ron K3MIY -- This mail sent through CSOnline Webmail http://webmail.csonline.net __________
The Ten-Tec 416 Titan II manual does not give too much info about C6 and C8 on the Load Shunt Board except that they are 320pf. Ten-Tec should be able to give you the minimum voltage rating required.
Yes, this addresses the CAUSE of the problem, which is likely something that has changed (broken?) in the antenna system (or the antenna tuner, if you're using one). Arcing is the result of higher th
Mouser.com will have them a lot cheaper! A 330pF ceramic cap at 6KV only costs 73 cents! Jerry W5JH "building something without experimenting is just solder practice" Bob and others On pg 43 of the l
Theirs is a lot difference in a ceramic cap that a door knob cap. Mouser.com will have them a lot cheaper! A 330pF ceramic cap at 6KV only costs 73 cents! Jerry W5JH "building something without exper
BINGO on difference! Do check the RF current rating for the caps of choice. It is not the voltage that frys them, it is the heating from RF current that makes them go pop! At legal limit power into 5
It all depends on what you are using it for. The door knob is a ceramic cap. If the use is to parallel the loading cap, then the high voltage is not needed. A 1000-1500VDC disk ceramic would be more
There's quite a few RF doorknob caps available from Russian sources as found on the big auction site. Usually available in qty of 3 to 6 pcs and reasonably priced. Now one may have to find space to r
Check with RF Parts Co. for high voltage capacitors, they used to sell some kit boards for Motorola high power solid state amplifiers. You could try the capacitor companies, could TT tell you the ven
Yep."Equivalent Series Resistance" (ESR) is a very important specification for a capacitor that carries significant AC current, and in a capacitor anywhere in that output stage is going carry a lot o