Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TenTec\]\s+Hercules\s+II\s+battery\s+arrangement\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TenTec\]\s+Hercules\s+II\s+battery\s+arrangement\s*$/: 8 ]

Total 8 documents matching your query.

1. [TenTec] Hercules II battery arrangement (score: 1): Author: ARDUJENSKI@aol.com; Date: Fri, 22 Sep 2006 23:45:36 EDT; I have spend about a week milling thru the Ten Tec Archives reading the posts regarding running the Hercules II on battery power. I have read the wide range of suggestions from a couple of 6v golf ca; /archives//html/TenTec/2006-09/msg00515.html (7,581 bytes)
2. Re: [TenTec] Hercules II battery arrangement (score: 1): Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>; Date: Fri, 22 Sep 2006 22:27:20 -0500; Like selecting a battery system for back up and for a RV, there are arguments in all directions. Sometimes one gets the most power for the buck going with 6 volt golf car batteries. Two in series. Th; /archives//html/TenTec/2006-09/msg00516.html (12,220 bytes)
3. Re: [TenTec] Hercules II battery arrangement (score: 1): Author: Ken Brown <ken.d.brown@hawaiiantel.net>; Date: Fri, 22 Sep 2006 18:52:23 -1000; Hi Alan, You probably do not want to use a "standard" battery charger. Many battery chargers do not have much (or even any) filtering. They may put out a half wave rectified ( lots of 60 Hz ripple ); /archives//html/TenTec/2006-09/msg00517.html (11,767 bytes)
4. [TenTec] Hercules II battery arrangement (score: 1): Author: "Joe" <n9vx@myway.com>; Date: Sat, 23 Sep 2006 16:48:36 -0400 (EDT); Alan, I have used an Interstate brand 100 ah deep cycle marine battery with a Battery Tender Plus 1.23 amp trickle charger for a few years on my Herc II and it works perfectly. The charger stays conn; /archives//html/TenTec/2006-09/msg00534.html (9,231 bytes)
5. Re: [TenTec] Hercules II battery arrangement (score: 1): Author: Bill NY9H <ny9h@arrl.net>; Date: Sat, 23 Sep 2006 13:10:45 -0500; I just went into the garage, ( my 9420 is mounted in a old kitchen cabinet on the garage wall , on the wall opposite my station setup). IT says 14 VDC... I knew it was not 12vdc,,, and I have no clu; /archives//html/TenTec/2006-09/msg00546.html (8,115 bytes)
6. Re: [TenTec] Hercules II battery arrangement (score: 1): Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>; Date: Sun, 24 Sep 2006 14:14:29 -0500; I don't know for sure about Tentec designs, some exciters seem to be more tolerant of varying loads than other brands, but in the optimally designed PA, the load impedance to the transistor is picked; /archives//html/TenTec/2006-09/msg00550.html (9,808 bytes)
7. Re: [TenTec] Hercules II battery arrangement (score: 1): Author: "Duane Budd" <dcbudd@charter.net>; Date: Mon, 25 Sep 2006 06:39:35 -0400; I read with some interest the responses to the question of using a Herc II on batteries. Jerry, K0CQ, gave his usual erudite, technical answers (usually well above my level of expertise). On this sub; /archives//html/TenTec/2006-09/msg00564.html (8,253 bytes)
8. Re: [TenTec] Hercules II battery arrangement (score: 1): Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>; Date: Mon, 25 Sep 2006 09:14:01 -0500; If you keep the batteries on charge while using the PA, the voltage will stay up pretty good, so the power output droop won't be as much as from running on the batteries alone getting down to 12 volt; /archives//html/TenTec/2006-09/msg00566.html (9,172 bytes)

Current List: 1 - 8
Page: [1]