- 1. [TenTec] Omni-6 rotary encoder (score: 1)
- Author: "Doug" <w5ga@arrl.net>
- Date: Sun, 13 Apr 2008 08:06:29 -0500
- When I spin the tuning knob on my O-6, the frequency doesn't change. RIT works fine, and keypad entry works fine also. Should I be looking for a new encoder, or could it be something else? 73, Doug W
- /archives//html/TenTec/2008-04/msg00152.html (7,288 bytes)
- 2. Re: [TenTec] Omni-6 rotary encoder (score: 1)
- Author: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
- Date: Sun, 13 Apr 2008 11:26:17 -0600
- Seems like I recall reading that there have been solder or cable connection failures between the encoder and its connections to the PC board. 73, Jerry, K0CQ _________________________________________
- /archives//html/TenTec/2008-04/msg00153.html (7,802 bytes)
- 3. Re: [TenTec] Omni-6 rotary encoder (score: 1)
- Author: Clark Savage Turner <csturner@kcbx.net>
- Date: Sun, 13 Apr 2008 10:41:21 -0700
- May be a loose connector behind the faceplate where the encoder talks to the processor, I'd check that first. You can test your own encoder by switching the connector from the RIT control over to the
- /archives//html/TenTec/2008-04/msg00154.html (7,662 bytes)
- 4. Re: [TenTec] Omni-6 rotary encoder (score: 1)
- Author: Thomas <ac7a@cox.net>
- Date: Sun, 13 Apr 2008 16:26:38 -0400
- There was a particular encoder that Ten Tec used for a while that wasn't of the best quality. I've had to replace my main tuning encoder. The Ten Tec parts department carries a replacement encoder. R
- /archives//html/TenTec/2008-04/msg00158.html (7,876 bytes)
- 5. [TenTec] Omni-6 rotary encoder (score: 1)
- Author: "Mark Kenward" <k8vf_mark@centurytel.net>
- Date: Mon, 14 Apr 2008 08:40:10 -0400
- Clark has it right. ALSO, sometimes the encoder connector gets a light coating of ??? on it which you can clean off . Try working the connector on and off a few times. It fixed my 2000 PLUS and saved
- /archives//html/TenTec/2008-04/msg00177.html (6,887 bytes)
This search system is powered by
Namazu