Author: Joe Papworth via TenTec <tentec@contesting.com>
Date: Thu, 25 Jun 2015 15:42:19 -0400
Radio Gurus, My Omni 6 Plus has an intermittant no RX/TX problem on ten meters only. The freq display reads correctly and the ALC led comes on as it should when I key the rig. I spoke with Paul at Te
When I sent my Omni VI+ in for that, on 160,and low output on 30M, they replaced the relays, all of them for each band. 73 de W6OGC Jim Allen Sent from my iPad _______________________________________
Author: Joe Papworth via TenTec <tentec@contesting.com>
Date: Thu, 25 Jun 2015 16:11:53 -0400
Good suggestion Jim but 10 and 12 meters share the same pair of relays, so it's not a relay. In a message dated 6/25/2015 4:09:18 P.M. Eastern Daylight Time, jim.allen@longhornband.net writes: When I
I sent mine in for an intermittent like that, only on 80 meters. Probably on oscillator board, which is under top cover, left front, UNDER the board shield. You need to dress the cables and insulate
Author: Joe Papworth via TenTec <tentec@contesting.com>
Date: Thu, 25 Jun 2015 17:39:54 -0400
Thanks Mark, I've replaced several of those relays over the years. I can do it in about an hour now. But I'm fairly sure that 10 and 12 use the same set of contacts so it's probably not a relay. I ha
Take a 4x6 inch card and start at the back, holding card vertically, only exposing 1/4 of the board at a time...as you go across, put the dryer to it, and if it comes on-or goes off, remove heat and