Since I have loaded the new v2.05x software, there is something weird going on. The Orion keys the Acom fine on 20 and higher. But on 40 through 160 when I hit the key, the Acom goes into "Arc Fault"
The only way to get an arc fault on an Acom is to actually have a place where the RF is causing an arc. I have had arc failts with my Acom 1000 and I always find some place where the antenna or feedl
Also, do you have the low pass filter from tentec for driving Acom amplifiers? Carl Moreschi N4PY 121 Little Bell Drive Bell Mountain Hays, NC 28635 -- Original Message -- From: <KZ5D@aol.com> To: <t
Carl, Thanks for the quick response. I'm not familiar with the low pass filter from TenTec. Info would be appreciated. Art KZ5D _______________________________________________ TenTec mailing list Ten
There's a file with the information at RFSQUARED .. http://www.rfsquared.com/cms-files/Acom-Orion%20Note.html Grant/NQ5T _______________________________________________ TenTec mailing list TenTec@con
Thanks Grant! I'll check this out now. de Art KZ5D _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
I think I know what's wrong... Maybe... I noticed with OII and my Alpha 91b that if I watch the power output LEDs that there is a very short duration spike in the power when the TX goes on off. If I
The filter does wonders on the early Orions. The other alternative is to use a small program that Krazy (sp?) at Acom has written for software control. I don't have it, but he mentioned it at Dayton
Ron N6AHA _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
Well I have almost the exact same set-up here. I had a similar problem (see http://lists.contesting.com/_tentec/2006-03/msg00298.html). My guess would be that your problem is NOT the N8LP box. I woul
I had a similar problem this past weekend during the SSB Contest. Talked to Alpha Power today who knew about the problem. DO NOT USE the KEYING LOOP was their advice. Just key (My Alpha 87A) amp with