Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TenTec\]\s+RX366\s+9mHz\s+output\.\.\.\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TenTec\]\s+RX366\s+9mHz\s+output\.\.\.\s*$/: 2 ]

Total 2 documents matching your query.

1. [TenTec] RX366 9mHz output... (score: 1): Author: cx7tt@4email.net; Date: Tue, 05 Jun 2012 20:01:30 -0300; Reading this thread leads me to believe that the RX366 board has a direct to the spare port on back of O II the 9mHz needed to run the P3 panadaptor. Is this correct or is the VE7's mod still needed; /archives//html/TenTec/2012-06/msg00040.html (7,087 bytes)
2. Re: [TenTec] RX366 9mHz output... (score: 1): Author: Carl Moreschi <n4py2@earthlink.net>; Date: Tue, 05 Jun 2012 19:39:50 -0400; You are correct but VE7TK's mod works much better with far less problems since you are using the main receiver's IF output. Carl Moreschi N4PY 121 Little Bell Dr. Hays, NC 28635 www.n4py.com ________; /archives//html/TenTec/2012-06/msg00041.html (7,417 bytes)

Current List: 1 - 2
Page: [1]