- 141. Re: Topband: [TowerTalk] Advise needed on phased beverages (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Wed, 12 Sep 2018 11:27:42 -0300
- You might also look at W8JI.com where he has a pair of phased Beverages in a box-like configuration spaced apart by 1/4 wave with the termination halfway across on one end and fed halfway across the
- /archives//html/Topband/2018-09/msg00093.html (11,915 bytes)
- 142. Re: Topband: Call for antenna ideas (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Sat, 15 Sep 2018 09:17:08 -0300
- Mike, you suggested a delta loop. It is important that if Simon decides to hang a delta loop between towers that you feed it a the corner rather than at the bottom. This should give you some vertical
- /archives//html/Topband/2018-09/msg00101.html (10,448 bytes)
- 143. Re: Topband: Toploaded vertical - SWR (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Wed, 19 Sep 2018 13:36:12 -0300
- An L network with a coil in series and a 500pf variable to ground might do the trick. You impedance of the antenna is to low and you need to bring it up. You can also try extending the top hat wires
- /archives//html/Topband/2018-09/msg00139.html (8,159 bytes)
- 144. Re: Topband: Gamma match success (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Tue, 16 Oct 2018 14:46:08 -0300
- Unless you use LMR 600 or Andrew heliax a cap made from standard RG-8 or 213 has its limitations. eBay has a ton of high current fixed caps very close to the value you need. Some are from Ukraine (Ru
- /archives//html/Topband/2018-10/msg00071.html (8,855 bytes)
- 145. Re: Topband: use of WD-1 Military field phone wire for bog and/or beverage (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Fri, 23 Nov 2018 17:05:19 -0400
- Terry, I have learned the hard way that WD-1A, in reverse Beverage two wire mode, is down many db's compared to the forward direction. The only way to make them work equally in both directions is to
- /archives//html/Topband/2018-11/msg00238.html (9,356 bytes)
- 146. Re: Topband: Detuning TX ant + QSK (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Wed, 28 Nov 2018 11:31:04 -0400
- I have an Ameritron QSK-1 never used and sitting on the shelf that has external outputs for relays. Works QSK with most any AMP $200 or best offer takes it. Herb Schoenbohm _________________ Searchab
- /archives//html/Topband/2018-11/msg00298.html (7,989 bytes)
- 147. Re: Topband: Polarization on 160m (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Wed, 28 Nov 2018 15:41:08 -0400
- So is the 70-year-old Collins 74A4 with its mechanic filters and single conversion method. Many times you could just roll the IX into a deep hole with the bandpass control and the signal would pop ou
- /archives//html/Topband/2018-11/msg00305.html (15,572 bytes)
- 148. Re: Topband: Polarization on 160m (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Wed, 28 Nov 2018 16:32:12 -0400
- That's correct but under these rules, the VI is not DX and counts the same as a W/VE two-pointer. Navassa which is certainly rare, especially on 160, is counted as KP2. Desecheo KP5 is counted the sa
- /archives//html/Topband/2018-11/msg00307.html (18,197 bytes)
- 149. Re: Topband: ARRL 160 Contest (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Thu, 29 Nov 2018 07:35:50 -0400
- Stan, at least I will be able to work you. Not being able for you to work DX when many are calling (some for a new one) and the band is wide open to EU, is not only embarrassing but a real let down f
- /archives//html/Topband/2018-11/msg00320.html (8,194 bytes)
- 150. Topband: Beverage feedline loop breaker (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Thu, 3 Jan 2019 13:47:17 -0400
- I am using a DXE RG6U coax interrupter about 35 feet from the Beverage feed point and it is working well. I have another Beverage without one. I would ask if I can fashion one out of two single wire
- /archives//html/Topband/2019-01/msg00001.html (6,846 bytes)
- 151. Topband: Amazing Conditions (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Mon, 7 Jan 2019 17:00:39 -0400
- On FT-8 (1840) there has been some amazing propagation with several ZS stations worked one hour before sunset and JA's worked 45 minutes after local sunrise. Working JA's by calling " CQ JA KV4FZ FK7
- /archives//html/Topband/2019-01/msg00009.html (6,683 bytes)
- 152. Topband: 30 Ja's worked today on 160 (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Sat, 12 Jan 2019 08:49:03 -0400
- Using FT-8 with a split 1840/1908 I was able to work over 30 JA's via a skewed SW path today. Amazing conditions and less polar absorption this direction. Herb, KV4FZ _________________ Searchable Arc
- /archives//html/Topband/2019-01/msg00021.html (6,523 bytes)
- 153. Re: Topband: FT-8 gentleman's agreement for 160? (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Fri, 25 Jan 2019 17:24:06 -0400
- Peter, Not all countries allow FT-8 ops on 1840. JA's work split on 11908. Last night attempts to work a VU2 he was only able to legally TX around 1816 with my FT-8 being on 1844. The agreement came
- /archives//html/Topband/2019-01/msg00124.html (7,890 bytes)
- 154. Topband: JA's came in droves today on 160 (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Wed, 30 Jan 2019 15:00:18 -0400
- This morning starting an hour before dawn 34 JA's were worked on FT-8 with a 1840/1908 split. The best path was straight west for me. I don't know how this path existed or what caused this to happen.
- /archives//html/Topband/2019-01/msg00176.html (7,483 bytes)
- 155. Re: Topband: JA's came in droves today on 160 (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Thu, 31 Jan 2019 15:02:13 -0400
- Exactly Ed, Just as SSB did to AM and digital modes are doing to RTTY. Soon it may be computers working computers with minimal operator supervision. Right now on FT-8 when statins call my CQ they are
- /archives//html/Topband/2019-01/msg00184.html (11,121 bytes)
- 156. Re: Topband: JA's came in droves today on 160 (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Thu, 31 Jan 2019 15:25:59 -0400
- What was interesting to follow was when Central Electronic came out with the first SSB unit and Hallicrafters followed. Art Collins was right behind as his SAC contract needed more efficient and reli
- /archives//html/Topband/2019-01/msg00186.html (13,391 bytes)
- 157. Re: Topband: JA's came in droves today on 160 (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Thu, 31 Jan 2019 15:53:15 -0400
- Please also give credit for FT-8 occupying only a few Khz'a around 1840 and compare this to a Top Band CW contest where it is at times difficult to find a clear spot from 1800 to 1950 and even higher
- /archives//html/Topband/2019-01/msg00191.html (10,479 bytes)
- 158. Re: Topband: Topband Phenomenon (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Sun, 3 Feb 2019 14:36:15 -0400
- This could be explained by a power increase when the station's amp came on after warm up. However, a sudden 20 DB is a lot of increase to explain by any means. Maybe contacting the G station could he
- /archives//html/Topband/2019-02/msg00043.html (8,004 bytes)
- 159. Re: Topband: LACK OF ACTIVITY (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Wed, 13 Feb 2019 21:01:35 -0400
- KH7XS have you tried FT-8 on 160. Plenty of activity at your sunset and beyond. Herb, KV4FZ _________________ Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
- /archives//html/Topband/2019-02/msg00126.html (7,899 bytes)
- 160. Re: Topband: Inverted L loading wire dialmma (score: 1)
- Author: Herbert Schoenbohm <herbert.schoenbohm@gmail.com>
- Date: Thu, 14 Mar 2019 17:49:39 -0300
- The "witches hat" as you call it makes an excellent top loading medium for Marconi antennas. I use them here on an AM tower with great success in improving the base impedance of a less than 1/4 tower
- /archives//html/Topband/2019-03/msg00038.html (9,543 bytes)
This search system is powered by
Namazu