Check here for possible source ID: http://www.arrl.org/sounds-of-rfi GL - Steve WB6RSE _________________ Topband Reflector Archives - http://www.contesting.com/_topband
Back in the day, did you use a 9 Mc audio phasing SSB exciter and a 5 Mc VFO to operate on 75m? Do you still have that working gear? If so, please reply off list. Thanks & HNY - Steve WB6RSE ________
The upcoming K1N operation from Navassa will undoubtedly have a significant effort on the low bands including 160. If you havent already or feel inclined to do so again, Im sure the team would welcom
Not bragging, bragging? Really? So why waste time posting it? Steve WB6RSE "The K1N operation is your only opportunity in 32 years to work this #1 Most Wanted Entity. It has been 22 years since the l
Ive also posted this on the RFI reflector. Im hearing a peculiar RFI tone on 160m and 80m. Its two tones. One is a long tone with a short OFF. The other is approximately 13 kc lower and is ON exactly
Lets see. You likely have thousands if not tens of thousands invested in gear and antennas. You have a computer and a monthly ISP bill. And a monthly electric bill. These guys unselfishly invested th
The 66th International DX Convention in Visalia, California is now history. The Top Band Dinner was held on Friday, April 17, 2015. Attendance set a new all time record. Special thanks goes to Bob Al
The 66th International DX Convention in Visalia, California is now history. The Top Band Dinner was held on Friday, April 17, 2015. Attendance set a new all time record. Special thanks goes to Bob Al
4O3A sells a variety of products for station control and antenna switching: http://4o3a.com Steve WB6RSE _________________ Topband Reflector Archives - http://www.contesting.com/_topband
Its an easy problem to solve. Just change every country with districts into multiple DXCC entities. WØ-W9. Ten new countries. VE1, VE2, VK1 etc. Move to another country, start all over. And restart D
Dont know if this Rev 5 is the latest as Larry made some value changes over time. www.mtmscientific.com/preamp.pdf Steve WB6RSE Now that we've all retested the broken link, does anyone have a copy of
Getting back to CO8DM's original question about a preamp to use with a flag. If the receiver noise level pops up and then drops when a receive antenna is connected and then disconnected, then its lik
The mast of my RX flag is 20-25 ft from my 160/80m shunt fed tower. I run a KW+ on the low bands. I use an Array Solutions AS-RXFEP RF Limiter (aka FES etc.) in line with the flag at the rigs RX Ant
Im looking for WiFi router recommendations that support the latest standard, 802.11ac, and that have minimal if any RFI birdies. Netgear? Model numbers? Others. Off list replies preferred. Ill post a
Recomendations received for Linksys and Asus models. Tks to all who replied. Steve WB6RSE _________________ Topband Reflector Archives - http://www.contesting.com/_topband
Recomendations received for Linksys and Asus models. Tks to all who replied. Steve WB6RSE _________________ Topband Reflector Archives - http://www.contesting.com/_topband
Recomendations received for Linksys and Asus models. Tks to all who replied. Steve WB6RSE _________________ Topband Reflector Archives - http://www.contesting.com/_topband
QSOd Oliver W6NV at ZD8W on 10m. His schedule for tonight, Nov 13: JA and EU: Will start on 80 @ 21-22Z and move to 160. USA West Coast: @ 05Z will start on 80. Move to 160 around 06Z. Will be on160
I shunt feed my 54 ft free standing 3 section crank-up tower for 160m and 80m, remote relay band switchable omega match. 2:1 SWR bandwidth is around 40+ kc on 160 and about 20 kc on 80. 3/8 solid gam