- 21. [TowerTalk] Ring Rotor problem ? (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Thu, 19 Nov 1998 08:55:32 EST
- I just replaced the motor (not the whole drive box) on a small Tic Ring... It's a hundred bucks... The worm drive on the end of the motor shaft turns a nylon ring gear, which developed stripped teeth
- /archives//html/Towertalk/1998-11/msg00592.html (7,826 bytes)
- 22. [TowerTalk] Re: linear loading (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Thu, 19 Nov 1998 10:15:37 EST
- And, as I remember, Tom commented that it took some 900 computer runs using manual iteration to develop the Force 12 basic design... Denny -- FAQ on WWW: http://www.contesting.com/towertalkfaq.html S
- /archives//html/Towertalk/1998-11/msg00595.html (8,122 bytes)
- 23. [TowerTalk] 402CD - XM240 questions (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Wed, 7 Oct 1998 08:36:32 EDT
- Danny... There are a few professional hand wringers on this list and they will rant and wail no matter what you do... These folks will scream that if you are employed by the manufacturer that your op
- /archives//html/Towertalk/1998-10/msg00132.html (7,930 bytes)
- 24. [TowerTalk] new qth - new problems (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Mon, 12 Oct 1998 08:57:27 EDT
- Hi Frank... Well, you have a tiger by the tail if you are going to bring the hot end of a radiating wire near a house where other folks are trying to watch a Muntz tv with a 21mc IF and listen to k-m
- /archives//html/Towertalk/1998-10/msg00302.html (8,744 bytes)
- 25. [TowerTalk] Response to R for math (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Tue, 13 Oct 1998 08:59:44 EDT
- << Question then...how much additional strength, if any, is added to a 2" mast that is filled with epoxy cement or similar substance that is poured in and becomes solid or semi-solid >> ZIPPO! ... De
- /archives//html/Towertalk/1998-10/msg00342.html (8,720 bytes)
- 26. [TowerTalk] Response to R for math (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Wed, 14 Oct 1998 11:37:19 EDT
- Hmmm, My ZIPPO seems to have light someones fire.... It wasn't intentional and I have not replied in any fashion until now, so there cannot be any kind of a flame war because I'm not playing... The o
- /archives//html/Towertalk/1998-10/msg00411.html (9,712 bytes)
- 27. [TowerTalk] Response to R for math (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Wed, 14 Oct 1998 11:52:25 EDT
- << In a message dated 10/13/98 12:17:44 PM Eastern Daylight Time, W4EF@pacbell.net writes: << The idea does beg an interesting question though, how does one calculate the bending strength of a mast m
- /archives//html/Towertalk/1998-10/msg00414.html (8,872 bytes)
- 28. [TowerTalk] SB1000 BANDSWITCH (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Thu, 15 Oct 1998 10:14:35 EDT
- << Another is exciters that put out sharp envelope peaks or spikes. My ICOM 706 whacks out almost 200 watts upon key closure (even if the drive is set for 30 watts or less), overdriving the PA and fo
- /archives//html/Towertalk/1998-10/msg00466.html (8,509 bytes)
- 29. [TowerTalk] Short-Snort (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Sat, 17 Oct 1998 08:42:51 EDT
- << BTW: I have never owned an HF ICOM radio and never will............ >> Hmmm, that is emotion, not intellect, and really has no place in this discussion... The IC-706 is not the only rig with this
- /archives//html/Towertalk/1998-10/msg00530.html (8,200 bytes)
- 30. [TowerTalk] 4 Elephant antenna (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Sun, 18 Oct 1998 09:46:08 EDT
- Talk about boom envy!... wow.... Denny -- FAQ on WWW: http://www.contesting.com/towertalkfaq.html Submissions: towertalk@contesting.com Administrative requests: towertalk-REQUEST@contesting.com Probl
- /archives//html/Towertalk/1998-10/msg00572.html (7,223 bytes)
- 31. [TowerTalk] M2'd Orion 2800 (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Sun, 18 Oct 1998 10:10:59 EDT
- << Will take some time getting used to the digital readout...Sure miss the Analog pointer on the Hy-Gain control.... I've had a couple of stern talks with them about the control box... They just keep
- /archives//html/Towertalk/1998-10/msg00576.html (7,799 bytes)
- 32. [TowerTalk] A Question of GAIN (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Mon, 19 Oct 1998 08:38:41 EDT
- Josh, each time you double the number of antennas in an array you get a maximum of 2 + a fraction dB.... The very best you are going to see with a 4 stack is 9 + - dB (roughly)... And secondly, on hf
- /archives//html/Towertalk/1998-10/msg00631.html (8,974 bytes)
- 33. [TowerTalk] Folded Monopole (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Mon, 19 Oct 1998 09:06:13 EDT
- Larry... You are going in the right direction... Put down as many radials as you can as this will do more to enhance your signal on 160 than any other factor, bar none.... Length is not critical, jus
- /archives//html/Towertalk/1998-10/msg00633.html (8,141 bytes)
- 34. [TowerTalk] Antenna Parts (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Thu, 22 Oct 1998 10:44:15 EDT
- Does the collective list have more complete address / phone numbers for the following manufacturers... Industrial Retaining RIng Co. - Irvington, NJ Au Veco - Fort Mitchell, KY Rutland Arrays - New C
- /archives//html/Towertalk/1998-10/msg00813.html (6,748 bytes)
- 35. [TowerTalk] KLM KT34-XA Refurbishing (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Fri, 23 Oct 1998 09:00:36 EDT
- My KT34XA took a major hit in May measured at 110mph at the airport... It was broadside to the wind and 4 of the elements rotated on the boom into the vertical position... One element bent about 5 de
- /archives//html/Towertalk/1998-10/msg00840.html (9,071 bytes)
- 36. [TowerTalk] More on KT34XA (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Fri, 23 Oct 1998 16:00:40 EDT
- You got ripped.. In the future: The Dillsburg Aeroplane Works - 717/432-4589 Tell Mr. Vogelsanger that Dennis O'connor from Hemlock, Michigan sent you... Denny -- FAQ on WWW: http://www.contesting.co
- /archives//html/Towertalk/1998-10/msg00850.html (6,908 bytes)
- 37. [TowerTalk] Solder-It Portable Iron (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Fri, 30 Oct 1998 13:52:11 EST
- I just purchased the newest Solder-It iron, the #120.... This is some kinda soldering machine... (Beats the heck out of the Weller PyroPen that I can't keep working....) It has a built in striker wit
- /archives//html/Towertalk/1998-10/msg00998.html (7,417 bytes)
- 38. [TowerTalk] TIC General Corp. (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Fri, 30 Oct 1998 14:19:31 EST
- Jeezzzzz.... The TIC Ring broke down again... The gearbox chewed up the nylon ring gear inside... I'm stuck here at the office and I don't have the manual with me... DOes anyone have the phone number
- /archives//html/Towertalk/1998-10/msg01000.html (7,239 bytes)
- 39. [TowerTalk] TIC General Corp. (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Fri, 30 Oct 1998 16:17:39 EST
- Hey thanks guys.... You can tell how upset I am with their abortion, I couldn't even remember the number.... For those developing flaky direction pots it is the time of year to bring the motorbox dow
- /archives//html/Towertalk/1998-10/msg01004.html (7,232 bytes)
- 40. [TowerTalk] TIC General Corp. (score: 1)
- Author: CQK8DO@aol.com (CQK8DO@aol.com)
- Date: Sat, 31 Oct 1998 08:58:40 EST
- Hi Barry.. Well, I also replaced my existing pot with the their newer recommended pot, and STILL had a problem not long after that... I got a spray can of teflon lubricant from the local hardware sto
- /archives//html/Towertalk/1998-10/msg01009.html (8,053 bytes)
This search system is powered by
Namazu