Hello Everyone, I have a antenna project that calls for a 200 to 250 foot run of 75 ohm hard line - but in spite of reports of cheap (or free) CATV hardline being available from the local cable compa
Hello Everyone, I have a antenna project that calls for a 200 to 250 foot run of 75 ohm hard line - but in spite of reports of cheap (or free) CATV line being available from the local cable company I
Hello All, In regard to the water resistant enclosures available at reasonable cost. In the past I have used what are referred to as "Sportsmen's Dry Boxes". These are plastic (possibly polypropylene
Hello All, It seems that I read that there can be a corrosion problem if you ground the guy wires anywhere close to the steel screw-in ground anchors due to the small electric current the may run bet
Is it possible to use an analyzer to check transmission line length if the end is terminated in a balun such as those used on the KT34A? - Possibly by using it at a much higher or lower frequency tha
Would like to locate a KT34A or XA within reasonable driving distance of central Wisconsin. Please e-mail direct. Thanks - 73, Paul / K9KDR _______________________________________________ ___________
I currently have a KT34A at the top of my 70 foot tower - I was planning on stacking another at about 45 feet. However, in searching for another one I ended up with the XA version - which I was plann
What is the preferred method to side mount a fixed position tri-band beam to Rohn 25G? Thanks - 73, Paul / K9KDR _______________________________________________ ______________________________________
Hello All, I would just like to thank all of you who responded to my request for ideas on side mounting a tri-band beam to my tower. There were a lot of good ideas! With all the input, I feel confide
Anyone have a good Ham IV rotor and controller that they may be willing to part with? Please e-mail direct. Thanks - 73, Paul / K9KDR _______________________________________________ _________________