Bama has the manual for it on their web site. Its part of a sloper antenna setup for 30, 40, 80, & 160 meters if its the complete SAS-1. http://bama.edebris.com/manuals/ampsuply/sas1 Stephen Lee, N7R
The short answer is, "yes they can." There is a PDF file that details the required wind loading "design to" that can be perused by googling "antenna wind load for seminole county florida." Your QTH o
Yes, as an unwitting 9-year old under the supervision of my mother, I did perform that experiment way back in the summer of 1958. Much was learned: a) my being was electrically conductive , b) bare c
Chuck's, W5PR, advice is correct ! Page 5, near the bottom of the page, of the StackMatch manual states: "Actually, to keep the contacts from silver oxide build-up, the manufacturer of the relays rec
Good morning to Jorge Diez, CX6XM, and fellow towertalkers, I have 2 reels of Commscope P3-625-JCASS-SM-PR977 (flooded, 75 Ohm, Al shield, Cu coated Al center conductor). These have foot markers prin
Greetings to all, For the Butternut HF coil, check DX Engineering's Butternut parts web page. There's a good picture of the coil. On that picture I count 17 coil turns along the top. I'm holding an o
Yes, click on the link for BookBaby.com then once in the BookBaby site click once more on the Barnes & Noble link. You'll find that Barnes & Noble has it for sale on pre-order for $13.45. Release dat
I see you are located in Sun City West, Arizona. Thereis a machine shop community club there in Sun City. Last time I looked into it, the club was populated by some very capable machinistsalong with
Greetings to all, I agree with Grant Saviers, KZ1W, on recommending Tempco magnet-wire. Tempco guarantees their product to be USA manufactured. I use their GP/MR-200 grade magnet-wire rather than the
https://www.anythingtruck.com/product/270-E7664.html Euclid E-7664 Inner Axle Nut, 3-1/2"-12 Thread, Used on Meritor TP Axles with HM518445 Bearings $7.89 Stephen Lee, N7RV de John/K4WJ _________