Im going to have to string some coax out on the ground on a temporary basis over the winter - and wondered if the neighborhood muts may consider that coax as a chew toy? Any experience there? 73/jeff
Where can a guy buy this stuff in say 1000 or so lengths? 73/jeff/ac0c www.ac0c.com alpha-charlie-zero-charlie _______________________________________________ ________________________________________
I have an elevated vertical standing about 75 tall - with 10 elevated radials at about 8. I need to ground the beast somehow for lightning events. Theres a shunt coil between the vertical element and
Is a tailtwister T2X adequate to turn a DB36? The beam the guy is putting would be located just slightly below the top of the surrounding trees in a residential neighborhood so I dont expect the beam
Our FD CS3 built to book specs is resonant a bit high on 15m and pretty high on 10m. If you have a set of known-good dims for this antenna we would appreciate having them. 73/jeff/ac0c www.ac0c.com a
Ive been trying to get the L5PDF-RPC to mount on some AVA5 hardline. It seems to not make contact with the center conductor no matter what I do. Its a pretty old connector that Andrew has not made fo
Looking for the assembly instructions or whatever sort of manual came with these ancient Telrex beams. 40M329 3-element linearly loaded 40m beam 20M646 6-element 20m beam Appreciate any info you may
Whats the best way to connect the copper wire/strap to the 55G tower leg? Im planning to clean the galvanized leg, wrap the leg with a layer of 0.005 SS shim stock and then use a couple of SS hose cl
In the discussion of the ground connection, a mix of guys commented or sent pics of round conductors where others are using strap. The general comment was that strap is better which I think means low
I want to cut a slot in the yard about 12 wide and about 12 deep to accommodate tower wiring here on the site. In total the runs are about 1400 foot. Is a trencher the right tool for that job? I have