Hi Jim Been following this thread with considerable interest. However, I can't figure out what you're doing here. What is door stop molding and what problem is it solving for you? Construction materi
Surely you wouldn't need such a high capacity iron if you didn't slobber on the connector? Or is it that the tip is water cooled and when it leaks the iron is said to slober? 73, Jim VE7FO -- Origina
1500W for up to 20 seconds according to their web site 73, Jim VE7FO that small implies that it isn't rated for 100% duty cycle: I'll bet it gets mighty hot, mighty quick at that power. A smaller one
I have a number of filters and switches to wire up in my QRO station. I would like the necessary coax jumpers to be thinner (0.25" ?) and more flexible than, say, RG 213. They will be terminated by c
Oops oversight on my part. 50 ohms 0-30 MHz 1500 watts Jim, VE7FO Depends on what frequency and average power your running. -- Bryan Fields 727-409-1194 - Voice http://bryanfields.net _______________
WOW Tnx very much for all the useful info. And, yes, all these jumpers and switches will be between the amp and antenna and so will need to be able to handle QRO. I want to be able to configure my mo
Excellent. Thanks very much, Jim. Also, thanks for all the good stuff you do for ham radio. 73, Jim VE7FO Look for a vendor selling Harbor Industries RG400 for about $2.23/foot in 100 ft lengths. I w
Thanks very much, Dave. I'll check it out 73, Jim VE7FO I faced that same problem of wanting to support the whole range of contest operation modes. My solution was to take the existing 6 separate ban
I too would like to know which brand 73, Jim VE7FO Which brand? Thanks, Jim _______________________________________________ _______________________________________________ TowerTalk mailing list Towe