Any ideas on ground rods when you have solid shale at about 3 feet down? Have tried to drive one 8 footer so far and got about 4 feet and that was it. I was thinking of driving one horizontal in the
The "how vertical is vertical" question raises another question. If I put up a wire vertical, how vertical does it have to be? In-other-words, I have a tree that is 50 feet high, or even 60 feet high
The "how vertical is vertical" question raises another question. If I put up a wire vertical, how vertical does it have to be? In-other-words, I have a tree that is 50 feet high, or even 60 feet high
Looking for recommendations. Considering the interlaced 4 ele 20 and 2 ele 40 from Force 12, or a monoband 20 and the Cushcraft 2 ele 40. Price of the Force 12 is just over $1000 and I have a mono 20
Lost my notes on this: Need winding/construction info for a 16:1 transformer for a loop receive antenna. Thanks 73 Bill _______________________________________________ See: http://www.mscomputer.com
For sale is a CDE Ham-II rotor and control box in very good condition. . Control box with north centered meter. No u-bolts are included, but have lower tail piece. Rotor is working , bought as a spar
KD9SV DXPedition Model Preamp, combines the Front End Saver, dual band (160-80 meters) variable gain pre-amplifier and a four-position antenna switch in to one easy-to-use package. Will work with all
OK, maybe a dumb question, but here goes. Just moved to new qth. For a few months I will be running in "stealth" mode until I settle into the new neighborhood. Trying to avoid "fishing" 50 ohm coax t
I have a GAP Challenger that I am rebuilding. It appears to have all of the parts and pieces and I have the manual. I have two questions before I proceed with the coax wiring. 1. The top section wher
Scott, I've replaced that part on a couple of Hygain rotors, including the T2X. There's not an abundance of wire, but enough to do the job with no problem. 73 Bill bottom rusted (which I those and op
Where can I get the OD colored multi-strand rope, I think it is 1/8 or 3/32. Used to get it in 500 foot spools, for hanging wire antennas etc. 73 Bill K3SV ___________________________________________
If you have a feedpoint impedance of 32 ohms on an inverted "L" for 1.8 mhz, can anyone venture a guess as to what the impedance would be of the same antenna at 3.5 mhz ?? thanks, Bill ______________