- 1. [Towertalk] Draining battery on MFJ259B (score: 1)
- Author: k6xx@juno.com (k6xx@juno.com)
- Date: Sat, 4 May 2002 07:28:11 -0700
- Ar solution that works for me: Insert a coaxial power connector (that's POWER, not a PL259!) into the external power jack. This disconnects the internal battery. The ground lug and antenna connection
- /archives//html/Towertalk/2002-05/msg00088.html (7,578 bytes)
- 2. [TowerTalk] Front to Back Measurements (score: 1)
- Author: k6xx@juno.com (Bob Wolbert)
- Date: Thu, 13 Dec 2001 07:53:29 -0800
- Your rig's internal attenuator is generally quite accurate. Even using 5% resistors, the maximum error is about a dB, and is typically much less. This gives you accurate reference points with step si
- /archives//html/Towertalk/2001-12/msg00321.html (16,367 bytes)
- 3. [TowerTalk] Amplifier Interface (score: 1)
- Author: k6xx@juno.com (Bob Wolbert)
- Date: Thu, 8 Nov 2001 10:51:55 -0800
- Kevin, It is not necessary, nor desired. What would be useful is using the switched +13V on the remote connector to drive a transistor to then key your amp, saving the several ms internal relay delay
- /archives//html/Towertalk/2001-11/msg00195.html (9,319 bytes)
- 4. [TowerTalk] Driving Remote Relays--simply (score: 1)
- Author: "k6xx@juno.com" <k6xx@juno.com>
- Date: Fri, 10 Dec 2004 15:47:50 GMT
- Remote Ant. Switch Operators: Here is perhaps a simpler (and certainly more efficient) solution for sticky relays. Given that relays need a higher 'activate' current than 'hold' current, what we'd re
- /archives//html/Towertalk/2004-12/msg00236.html (8,244 bytes)
This search system is powered by
Namazu