thay make some real small backhoe's i'm thinking of one that are 4 ft wide and like 5-6 ft long and can dig a hole 5-6 ft deep bobcat make one and i know of one built like a log spliter and about the
for under streets thay make a two or 3 or 4 compartmet pully liner for that one pull roop is each devided part and it cant tangel like visquean butt havey and will go in old conduwits just fine and i
with 20 yeasrs or home and store wiring you for got c.rempve all wire and pull ropes and repull tham with the new ones or d. wiring a store i mite scrap the old wire and pull new wire in sorry for th
if there is biger wires thay go on the motor I WOULD think kb9yku the what unit to Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and ask for Sherman, W2FLA.
i would think of 2 or 3 or 4 of the 2 in black stuff used for well piping pellyurathin (not spelled right) street lights are wired with it and thay plow it in leaving 4-6 ft at each street light and
raping it with landscaping fibric did you use the sold stuff or the stuff with holes i bet the holey stuff is less work to find ft.) then out even problems Weather Stations", and lot's more. Call Tol
any elct supply house the big box home stores mite have it i would call frist unless there close ken kb9yku Weather Stations", and lot's more. Call Toll Free, 1-800-333-9041 with any questions and as
tham1 gel size paint cans are tham all dummy loads or is some/one a duplexer ken -- Original Message -- From: "Peter" <pb0aiu@pi4cc.nl> To: "Stephen Reichlyn" <Stephen.Reichlyn@ryansci.com>; <towerta
how abote heat shrink the kind with hot melt glue inside used for coax water proofing if youcan buy tham in long parts of the right size ken kb9yku Weather Stations", and lot's more. Call Toll Free,
sounds like cable tv hard line the kind used on the light poles if so some avt hams mite use it on there 910 mhz run as most use 75 ohm for that use and rg6 sold by the home stores has like 4-6 db lo
i was told a salesmen is programmed to lie to make the sale is the Realtor you was dealing with getting his money from the sale of the land or was the buyer paying the Realtor if the buyer was paying
i was thinking cadweld was the name for that system look at http://www.contractconnections.co.nz/cadweld.shtml there is lots of makers making about the same systum i have used a hammer drill the kind
if i was burying it I'd put it in gray conduit gluing the joints and making ends water proof 1/2 in in under $2 for 10 foot 3/4 is about same price ball park and i buy it 100's of feet at a time at t
yes that is to stop the salt used on the hiways from eating the steel up your not going to salt your tower base like the state do the hiways you should not need it unless some thing in you earth or w
how big do it need to be can you use a 55 gel drum as a form or as a safety cage wane it get one drum deep add 2ed one or old home heating oil tanks ends removed i seen a parking lot lite pole instal
At 04:56 PM 3/4/2004, Scott Townley wrote: In the cell biz, I've been asked by zoning boards if we can't just bury the antennas, since they bury power and telco lines :-) yes Bury radax the feed line
At 05:44 AM 3/18/2004, FireBrick wrote: I'm a retired Chicago Licensed Mason Contractor. It MUST be a unified pour. Believe it or not, it's very hard to get concrete to stick to previously poured con