I have a rotator stuck at due South and need to free it. I know the rotator worked fine b4 installing a "Rotor-EZ" circuit in the control box. I just need the secret to unsticking it so I can proceed
I managed to get my T2X jammed CW again, this time the jumper wire trick around the limit switches didn't work. I then climbed the tower and yanked the antenna back and forth, but it failed to free t
I'm looking ot replace my coax runs. I will operate up thru 6 m, and lengths to 150 or so ft. I want coax that is low-loss, flexible for the rotor loops and long-lasting. I'm considering: CXP-1318FX
US Towers will sell you a driect replacement, tho I wasn't real pleased with what came with my 472MDP tower from them. It had only one tightening bolt and one "punch hole" to grab the mast with. It d
Anyone using either of these antennas? I'm chewing over a decision to replace my old DX Eng log which covers 17-10 m, with one of these antennas from F-12. Any experienced users out there that can of
My tailtwister won't twist its tail amymore- stuck pointing South. It was getting slower reacting the last few months. Anyone have wisdom for repair from the shack? I'm thinking leaky motor cap in th
My fellow Tower talkers, I made it down to the local Grainger Industrial Supply store today and bought two replacement caps for my tailtwister rotor control box's ac motor starting cap. Swapped it ou
Magnetic declination is not the same thing as magnetic deviation. I think you guys are talking about deviation from true North, whereas mag declination is the vertical angle the field lines make goin