Bravo Bill! I haven't read that one in quite a long time. Thanks for remembering. Matt KM5VI I'm writing in response to your request for additional information for block #3 of the Accident Report For
I agree with you Fernando - it would seem that something on the rigging to the tower section failed first causing the remaining rigging to unwind. I watched it again on a larger screen this time and
You might want to look into a mini-excavator. Matt KM5VI I intend to be putting up a tower that requires approximately 5'x5'x7.5' deep hole.I cannot get a backhoe behind my house. My gate opens to 48
TIC is 24 VDC and there are a number of rotor controller options aside from Green Heron. I am using six of the Arduino based k3ng type rotor controllers - two of these operate TIC ring rotors. The Ar
Change the terminal strip to a block off plate with a compression fitting to pass a cable whip through and make the connections in an external junction box. Matt KM5VI Did some searches and found a f
Hi John, I ran into the same issue a few years back. I drilled out the holes in the upper rotor housing to 3/8" inch and used these: https://www.uboltsdirect.com/product/3-8-u-bolts-round-38-x-3-14-i
I use a static drain choke in my homebrew arrestors. ANT port gets 31 turns of 18 AWG Thermalize on an Amidon T106-1 shunted to ground with a Littlefuse CG3 1.5kV GDT across it. TRX port gets a 220k