Btw, Does someone have part number and source (other than UST) for that rubber belt used in HDX589MDPL. This winter I was once or twice cranking up tower after some rains and belt was slipping on mot
I was just in garage and looked what I used when put up my towers and antennas few years ago, I eventually needed 2 units in same time so I have these: https://lug-all.com/products/1-1-8-ton-cable-ho
Hello, I have 2 UST 89 footers and had Yaesu G1000 rotator on one of them for few months before getting permanent solution (prop pitch) installed. For all this rotator installation and swapping work
Mike, I just built this filter from kit I had acquired couple years ago. All AM interference is gone with this filter online before my RX antenna preamp. I also tried it on my transmit antenna (to li
I have used such quarter wave top fed sloper on 160 for some years now. Tower, 89 ft UST HD crank up (which is never all the way extended) is on elevated pad. Other end of sloper is tied to rope from
Bob, I have organized couple group buys in past here in San Diego area for large qty of Fair-Rite toroids of all sizes and at that time I purchased from Mouser. Last couple weeks I purchased large qt
https://www.dxengineering.com/parts/cyt-cl200038sg I have tried many different U bolts and pretty much everything I could change is now changed to these available from DXE (link above). It is excelle
Did you figure this out ? I just worked on that tower with tilt fixture myself last week (1st time too). There is small sling that wraps around tower leg and connects with bolt to end of winch cable