I'm using BuryFlex from Davis RF because of the tough, inert jacket(according to the literature). I haven't had it up long enough to tell anything about it yet. It has pretty much the same specs as L
Take a look also at BuryFlex (9914F )by Davis RF. I'm putting a run of it up based on the claims about the jacket. http://www.davisrf.com/coax.php 73. Mike NF4L ______________________________________
Recently I read an interesting article about using toroid chokes to reduce noise. I can't remember where I found it, or where I put it. Does this ring anybody's bell? j3, Mike NF4L __________________
Thanks Jim, but yours wasn't it. Your article I have saved. _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting
Anyone using the Idiom Press RotorCard DXA know how to make it accept the rotation speed that's set on the control box? Mine turns the beam at the high speed rate when I use it via the computer. The
Thanks, Rob. I like the way it works! 73 Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http
Tod - I just tried it. The paddle is ignored, the rotor keeps turning. I don't know if that's the desired result. 73, Mike NF4L _______________________________________________ _______________________
I just finished replacing the top section on my R25 tower put up in 1994. I had used neversieze also. The ground crew put a little tension on the section via a gin pole, the tower monkey did a little
Dave, The specs are on the Yaesu website http://www.yaesu.com/indexVS.cfm?cmd=DisplayProducts&ProdCatID=104&encProdID=9CD2145C24AE53C5A6C62D7D703A9F3C&DivisionID=65&isArchived=0 Beware word wrap on t
http://www.farnell.com/datasheets/315929.pdf 73, Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.
I know yous said U.S. but here's an alternate. I owned one in a previous life, well made, and I liked the angled design. http://www.ve5si.sasktelwebsite.net/ 73, Mike NF4L ___________________________
I live in Florida and have a 4EL SteppIR at 80 feet, up 5 years. Last August, I took a lightning strike which totally wiped out my station. The antenna itself was not harmed, but the controller was f
Click on Rotator accessories (on the left), and scroll down. 73, Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing list Tower
I'll agree with Jamie about the Davis BuryFlex.. Prior to that I had LMR400 with the rotator loop being LMR400 microflex. 73, Mike NF4L _______________________________________________ _______________
AFAICT, there is no color code. You just have to match up terminal to terminal. The manual speaks of the importance of terminal 1 to terminal 1, and using the heavier gauge wires for terminals #1 and
Something like this, I think. http://www.flex-drain.com/ 73, Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk
These are NewAge (tm) owls. You have to find true north for them..... 73, Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing l
Put a dummy load on the far side and check SWR? 73, Mike NF4L _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesti