I have my new Tashjian W-51 tower installed and working but have found that I can only install my Ham-IV rotor by disassembling the rotor and reassembling it inside the tower section. I want to inst
I went all over the inside of the top tower section and found no tabs. My idea is to drill, tap, and put in short bolts where the tabs should be, sitting the rotator plate on the bolt heads. I do p
Hi Dave, I just installed a new Tashjian W-51 crank up tower which came with 2 Fulton K 1550 winches, one for tip over and the other for cranking up and down. I replaced them both. As I'm sure you
On 11/12/2017 2:22 PM, Jim Brown wrote: On 11/12/2017 1:49 PM, Bob K6UJ wrote: What I did was make sure the driver tube was well lubed with Penetrox and slid it out in 1/2 " increments tillit got dow