Everyone is going to Dayton and you will still have 1000 posts when you get back. So will I. 73, Les _______________________________________________ _______________________________________________ To
Mine is quiet. Les W2LK _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mai
This is the method I use too except I like to wrap the innermost tape layer sticky side out then overlap its ends with the next layer. This way, if you have to open the connection in the future, ther
Me too. Les W2LK _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/li
Where is Maasdam sold? Their web site is no help. Les W2LK _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.
Any thoughts on how this stuff will survive on the ground? Les W2LK _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@co
To stop the plastic from melting and pins from moving, I use a mating socket. With the two plugged together I clip a clothespin type heat sink to the pin being soldered at the rear of the mating sock
Can you tell me which blade to look for. I take it that these are not the diamond edge blades. Les W2LK _______________________________________________ _______________________________________________
Can anyone suggest suggest a good (cheap) vendor for outdoor shielded (& direct bury) Cat5e, flooded heat shrink tubing and/or direct bury F6 or RG6 cable? Now that it's below freezing I'm working on
I placed an order with them about 3 weeks ago and received it about a week later. No problems. Les W2LK _______________________________________________ _______________________________________________
I have an older US Tower, model MDX-589. The motor is wired for 120V. The motor label clearly shows it can be set for 240V. I have had 240V brought to the tower site. Can someone tell me if the raise
Thanks all for the replies. I need to determine how the thing is currently wired before doing anything. It has the limit switch package which adds a little to the complexity but the consensus is to m
I just did this and rented the thing from them. The new oneshots need to be fired with a special device. No more open sparks, etc. Les --Original Message-- ___________________________________________
Al, Go here for the manual: http://www.m2inc.com/index2.html 73, Les W2LK --Original Message-- _______________________________________________ _______________________________________________ TowerTal
Hmmm. I seem to remember it was pretty much standard not to have a "Church Key" in one's ammo pouch in the NY National Guard and it was not used extensively in the field at Camp Drum either. Must hav
Bob, Try this URL. I have bought from him. Good prices and great service plus he's a ham. http://cgi.ebay.com/05-01293-UHF-Elbow-Coax-Adapter-PL-259-SO-239-UG-646-U_W0QQitemZ170185542887QQihZ007QQcat
There is a Yahoo group called hamautomation that was started for this purpose but it has been inactive for a while. You might consider using it if you think the name is OK. Les W2LK _________________
Ryan, PL-259s work perfectly with LMR400. You can solder or you can get ones that crimp or a combo of outer crimp and center conductor solder. If you use crimp style, you need to make sure they are s
I have used several reels of their cable. No problems. Les W2LK --Original Message-- _______________________________________________ _______________________________________________ TowerTalk mailing