Thanks for the reply Matt. I have had a few Beverages and a SAL 30. I found that 300 was too short to be of much use, but occasionally came in handy. At one point I had 4 Bevs with only the EU being
If someone has a copy of or link to that article, I would like to read it. The logic of it mystifies me. I would think the Yagis, assuming they are pointing the same direction, would put twisting tor
Well my masts are very heavy. Weight of the antennas is not a real factor. And saying someone is not an engineer doesnt help either. I believe It is a fact that the wind forces on Yagi antennas point
I dont understand the physics of how that works. If I imagine that I am looking straight down from over the mast and I have a Yagi that has more wind area in the front than the back, then it will exe
Ok, I was thinking of broadside to the booms. Thats the ten meter thinking coming out in me. Small element wind areas. Thanks for the clarification. Chuck W5PR _______________________________________
Master Appliance has amazing heat tools that start with a flame and then you extinguish it and it uses a catalyst to reach higher temperatures than a regular butane torch. I have used one high on a t
I had some trouble with my Alpha amp and reached back to make sure the right angle connector was tight. It was so hot that it burned my hand. No more right angle connectors! Chuck W5PR ______________
Yes, thats a whole different ballgame from my hamfest junk. Chuck W5PR _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk
I dont see it on VK6YBs QRZ page. Chuck W5PR _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lis
Its the control box that has to be changed. On the ones with a physical needle that turns, you just remove the glass and pull the needle off and put it back in the opposite direction. Chuck W5PR ____
I tried it with a couple of stacked 10 meter beams and found that it might occasionally allow me to copy a signal off the back by reducing the qrm from the signals coming from the front. Not worth th