Author: "WA3GIN in Alex. City, VA" <wa3gin@erols.com>
Date: Sat, 16 Dec 2006 09:03:28 -0500
Our Radio Club (www.w4ava.org) will continue supporting teaching the Morse code. What is the difference if someone is forced to learn the code to get their license then never uses it again after the
1st get a coordinated freq. pair then go for the most gain antenna with a good notch filter to keep the pager systems out of your input freq., with the most power amp with the least lost coax, top no
Great subjective opinions...prolly why antenna vendors sell all kinds of dufferent antennas...no one ever agrees on thus stuff, haha Have Fun, dave wa3gin -- Original Message -- From: <Cqtestk4xs@aol
Most will never have one of those beauties ;-) _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://l
Author: "WA3GIN in Alex. City, VA" <wa3gin@erols.com>
Date: Mon, 5 Mar 2007 18:32:17 -0500
The K9AY antenna is "not" a beverage and is matched differently. They are not in the same "signal-to-noise" class of antennas. Not to diminish the K9AY antenna, one can not compare apples with orange
The three or four big screws at the bottom of the pipe hold the brass plug. Remove the screws and slowly pull the plug out. Then you'll have access to the wires from the motor. I've done it a few tim
This topic needs its own reflector but I just hooked up a brand new PC with VISTA and LINKSYS tells me I need a new router because the three year old unit I have will not play with a VISTA PC....what
UPDATE: The Linksys had a bad port. The Linksys customer service reps were either idiots or just using the VISTA smoke to push product sales. _______________________________________________ _________
Thirdly, the reduction in surface tension removes significantly the possibility the rain hitting the elements will experience the necessary collision impact required to dislodge electrons responsible
Just practicing for 04/01 I wnder how many guys were out there this morning polishing antennas ;-) _______________________________________________ _______________________________________________ Towe
OK is a relative term and articles are generally subjetive opinions of one. Most folks understand that going into it. Not everyone cares about the .001 db gain potential and how they can all add up t
Jim, I have the same installation using a CT-100. I use schedule 40 PVC pipe 3/4" as stand-off. I drill out foles forthe u-clamp's threaded ends to pass through the PVC. You can adjust the lengths of
HAHA, Yesterday I received an email from a "new" general class that just upgraded from tech. He has been trying to work stations using a slinky antenna in his attack but didn't have any luck at all.
This thread is getting painful to follow... There are so many bad signals out there...give me a break. Just because a guy uses a flag pole, or gutter or wire in PVC buried in the ground is no excuse
Author: "WA3GIN in Alex. City, VA" <wa3gin@erols.com>
Date: Mon, 2 Apr 2007 18:47:59 -0500
It's not a lie...it is just not the entire story. If you few folks are so bent out of shape maybe should stop your whining and write a short paragraph that tells the rest of it and mail it to QST. Th
The new ham isn't brain dead...he just bought his rig last week and wanted to get on the air ASAP. I'm sure he'll figure out much of this stuff without me spoon feeding him. It seems to me that half
Cutler Hammer...great little unit that bolts on to your breaker panel. Remember that you'll need end point units at all your sensitive electronic equipment outlets as well. The whole house units get