I am sure that you will find usefull this program, named "PstRotator". http://www.qsl.net/yo3dmu/index_Page346.htm PstRotator handles almost every controllable rotator in common use: Prosistel "D" an
I hope somebody will find usefull the PstRotator program. It can be downloaded from www.qsl.net/yo3dmu/index_Page346.htm PstRotator handles just about every controllable rotator in common use: Prosis
PstRotator handles almost every controllable rotator in common use, provides automatic tracking for satelites and EME, and lots more. http://www.qsl.net/yo3dmu/index_Page346.htm Rotators supported: P
PstRotator - a program for antenna rotators control - just updated. More rotators and more loggers supported. www.qsl.net/yo3dmu/index_Page346.htm PstRotator handles almost every controllable rotator
Just to remember: is time to upgrade the program. www.qsl.net/yo3dmu/index_Page346.htm More rotators and more programs supported. And some new features, including using of QRZ.com. Type a callsig
Hi, You can try this software: http://www.qsl.net/yo3dmu/index_Page346.htm 73, Codrut - YO3DMU Would those unprintable characters perhaps be the data you are looking for? Many devices like this r
9600,8,N,1 A45<CR> (go to 45 deg AZ) A<CR> (select azimut, position request) A=45.1 S=4 M (Azimuth = 45.1 deg ...etc) For elevation change A with E. Heck, I am lazy! I hoped you would just tell me!
Hi Gerald, You can find attached both two protocols used by M2 rotators. Also you can use my PstRotator program and a free serial port monitor to see the messages to and from your rotator. 73, Co
You can download/upgrade the program from: http://www.qsl.net/yo3dmu/index_Page346.htm Automatically tracking with: AC Log, BBLogger, CC User, DX Monitor, DX4WIN, DXView, EasyLog 5, EME Syst
The PstRotatorAz program provides full control for the SteppIR antennas (Rotor & SDA100 controller), inclusive remote control over IP. You can download and test it from: http://www.qsl.net/yo3dmu/ind
You might find also helpful: PstRotatorAz http://www.qsl.net/yo3dmu/index_Page346.htm , a program for rotators control, is able to control the Channel Master rotors http://www.channelmaster.com/Anten