- 1. [TowerTalk] Hygain rotors (score: 1)
- Author: rthorne@tcac.net (Richard Thorne)
- Date: Thu, 22 Oct 1998 20:49:12 -0500
- Need some help with the wiring of the hygain rotors and the pin outs. What is connected to pin 1 and pin 3 on the back of the control box. I'm assuming this is the resistor pot in the rotor. I need t
- /archives//html/Towertalk/1998-10/msg00830.html (7,250 bytes)
- 2. [TowerTalk] Hygain rotors (score: 1)
- Author: Dick Green" <dick.green@valley.net (Dick Green)
- Date: Thu, 22 Oct 1998 23:32:16 -0400
- On my Tailtwister, pin 1 is the ground lead for the entire unit and pin 3 is one of the pot leads: "Pot Arm to + End". Pin 7 is the other pot lead: "Pot Arm to - End". The resistance between pins 1 a
- /archives//html/Towertalk/1998-10/msg00833.html (8,871 bytes)
- 3. [TowerTalk] Hygain rotors (score: 1)
- Author: JSheinb785@aol.com (JSheinb785@aol.com)
- Date: Thu, 22 Oct 1998 23:36:11 EDT
- Pin 1 is the GROUND. Pin 3 is the voltage supply for the pot & goes to one side of the pot. 73, WD5FHG Joe -- FAQ on WWW: http://www.contesting.com/towertalkfaq.html Submissions: towertalk@contesting
- /archives//html/Towertalk/1998-10/msg00834.html (7,071 bytes)
- 4. [TowerTalk] Hygain rotors (score: 1)
- Author: n3rr@erols.com (Bill Hider, N3RR)
- Date: Fri, 23 Oct 1998 06:03:59 +0100
- For a HAM IV: Pin #1 is the ground connection which also has the following connected to it in the rotor: wiper of potentiometer, one side of both motor windings, one side of the brake solenoid windin
- /archives//html/Towertalk/1998-10/msg00835.html (8,393 bytes)
This search system is powered by
Namazu