Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TowerTalk\]\s+M2\s+Orion\s+2800\s+question\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TowerTalk\]\s+M2\s+Orion\s+2800\s+question\s*$/: 5 ]

Total 5 documents matching your query.

1. [TowerTalk] M2 Orion 2800 question (score: 1): Author: "Dick Allardyce $N4RA$ via TowerTalk" <towertalk@contesting.com>; Date: Sat, 7 Jul 2018 17:14:02 -0400; While working on my tower yesterday I discovered a problem with my M2 Orion 2800PX rotator. I noticed a lot or rotational freeplay. Probably about 20 degrees. In addition, the output shaft wobbles ab; /archives//html/Towertalk/2018-07/msg00034.html (7,830 bytes)
2. Re: [TowerTalk] M2 Orion 2800 question (score: 1): Author: Les Kalmus <w2lk@bk-lk.com>; Date: Sat, 7 Jul 2018 23:23:31 -0400; I experienced this. The cause was the small 1/4" SS bolt into the top of the output shaft had come loose which allowed the shaft to drop. This caused a lot of play between the splines inside the base; /archives//html/Towertalk/2018-07/msg00039.html (9,175 bytes)
3. Re: [TowerTalk] M2 Orion 2800 question (score: 1): Author: Clay Autery <KY5G@montac.com>; Date: Sat, 7 Jul 2018 22:34:31 -0500; Wow.... with that much potential repair cost, I would replace that bolt with a cross-drilled bolt-head and safety wire it. ______________________ Clay Autery, KY5G (318) 518-1389 On 07-Jul-18 22:23,; /archives//html/Towertalk/2018-07/msg00040.html (9,087 bytes)
4. Re: [TowerTalk] M2 Orion 2800 question (score: 1): Author: Grant Saviers <grants2@pacbell.net>; Date: Sat, 7 Jul 2018 21:04:55 -0700; A used 2800 I acquired must have had the same problem. The prior owner put a cut off closed end wrench on this bolt, secured with another thru screw thru the handle stub so there was no way for the b; /archives//html/Towertalk/2018-07/msg00041.html (9,892 bytes)
5. [TowerTalk] M2 Orion 2800 question (score: 1): Author: "Jim Thomson" <jim.thom@telus.net>; Date: Sun, 8 Jul 2018 04:50:08 -0700; <Wow.... with that much potential repair cost, I would replace that bolt <with a cross-drilled bolt-head and safety wire it. ______________________ <Clay Autery, KY5G self centering guide is used. If; /archives//html/Towertalk/2018-07/msg00047.html (8,336 bytes)

Current List: 1 - 5
Page: [1]