Folks, I have a minor problem I'm trying to figure out, and thought one of you may have run across a solution or have some suggestions. I have 12ea 1/2" forged jaw-jaw Rohn turnbuckles that I want to
is the jaw wide enough to contain both of the eq plates? i.e. use the jaw's pin at the location on the locator plate... jaw may not be deep enough but you tell me... always best to avoid an extra pie
Suggestion 1: Buy another (12) eye-eye forged tb's with the same thread, swap one eye for one jaw on all (24) tb's, use (12) of the resulting e-j tb's and hamfest the other (12). Suggestion 2: Cut a
Hi Bill, I had a similar problem and dealt with it along the lines of Georges, N4Ua, #2 suggestion. I machined a block of steel to make connections. Look about half way down the page to see my soluti