I have a couple of phasing lines for an old Colatcho 4-square controller that I'd like to rebuild. They're made of Saxton 8315 and 8316 52-ohm cable. I can't find any specs for these cables online. D
Hi Dick, Best way to learn it is to measure it. Find the null frequencies of a known length of the cable as a stub, then do the arithmetic. Try to make the measurements at frequencies near where you
Thanks, Jim. Could you summarize the procedure (e.g., measure the cable open or shorted) and arithmetic for me? 73, Dick WC1M known _______________________________________________ ___________________
k9yc.com/Coax-Stubs.pdf Put a connector on one end, connect to the analyzer, leave the other end open, vary the frequency of the analyzer until you see a null (near zero ohms). That is a quarter-wave