- 1. [TowerTalk] winch to drill adapter (score: 1)
- Author: <craig@thompsonet.com>
- Date: Mon, 30 Jun 2008 12:20:40 -0500
- Does anyone have a suggestion for a winch to drill adapter? Thanks, Craig K9CT _______________________________________________ _______________________________________________ TowerTalk mailing list T
- /archives//html/Towertalk/2008-06/msg00703.html (7,117 bytes)
- 2. Re: [TowerTalk] winch to drill adapter (score: 1)
- Author: "Rick Karlquist" <richard@karlquist.com>
- Date: Mon, 30 Jun 2008 10:38:58 -0700 (PDT)
- Take off the nut that holds the winch handle. Leaving the handle in place, replace the nut with a "coupling nut". A coupling nut is used to connect threaded rods together and will be sold in the hard
- /archives//html/Towertalk/2008-06/msg00704.html (9,090 bytes)
- 3. Re: [TowerTalk] winch to drill adapter (score: 1)
- Author: Joe - WDØM <joe@wd0m.com>
- Date: Mon, 30 Jun 2008 11:39:16 -0600
- Hi Craig, Check my web site for an idea: http://www.wd0m.com/ Click on "Ham Radio", then "Winch Adapter - 1/2 Inch Drill". I have NOT used this - just an idea I plan to pursue at some date --soon. Ho
- /archives//html/Towertalk/2008-06/msg00705.html (7,672 bytes)
- 4. Re: [TowerTalk] winch to drill adapter (score: 1)
- Author: jim Jarvis <jimjarvis@optonline.net>
- Date: Mon, 30 Jun 2008 17:51:15 -0400
- Depends highly on the winch and the drill, I would say. The winch/gearbox system on my ab621 had a 1" square boss, which I had mated to a shaft which would go into a 4:1 right angle drive for my 1.2"
- /archives//html/Towertalk/2008-06/msg00710.html (7,976 bytes)
This search system is powered by
Namazu