I did a simple search using "Google" and came up with several hits. Among them is this list of articles. http://webhome.idirect.com/~griffith/hr/hrind29c.htm Good luck w/ ur project 73, Bill, -=WF4R=
I must tell my opinion (for what it's worth) zero, right? HI. I think that if the League decides to drop the VHF contest listings from QST it would be a terrible dis-service to everyone involved! I m
Jacob, I refurbished my Rohn 25 about two years ago. It may not have been in the shape yours sounds like. I'd recommend not using a grinder at all. There are a number of paint remover products that a
Scott, Look for a Gov. surplus coax switch made by Transco. Transco went bankrupt but was bought by Dow Key Relay. Transco made some very nice four port coax switches with a solenoid for each port. T
Thanks for the reminder Bill, I'm planning to be on and make some "noise" also. Hope to work you. Still working on the transverter, should be able to have it on by the June contest. 73, Bill, WF4R, F
I think maybe the manufacturers should read this reflector. Then they might get an idea of what to sell. I for one would like to see a manufacture support the 222 band with an all mode. 6, 2, 432 see
You may want to try using "VHF Cont" by KC6TEU. It is fully cabrillo complient and I've used it for the past three years. I find it quite adiquate. 73, Bill, WF4R
Maybe not the greatest but not the worst either. Here's is my "bragging" results. I enjoyed the contest even though I've done better. The bands were obviously pretty dead for most of the time. ARRL-S
George, I've downloaded N1MU's Rover logging program and it looks very user friendly. Check this out. http://www.2ub.org/roverlog/ Be sure to download the manual. Good Luck es 73, Bill WF4R
I'm guessing, but wouldn't this also attenuate your receive signal? which of course would be very undesirable. If you can only install it on the transmit side then no problem. The ARRL handbook also
Hello ALL, I've recently come across a Mitsubishi RF Module with p/n M57712H silk-screened on its face. I'm am not able to find any spec's on this particular animal. I would appreciate it if anyone o
Thanks for the update Bill. It looks like I'll be off the air for a few months until I can get my arrays back on the tower. Hurricane Isabelle did the honor of removing things for me. The tower survi
VHF, et all, I've been reading this thread with great interest because I believe there needs to be some changes in how the reporting is done in QST. I think that it is very obvious that those in the
I disagree with your asertions that ERP should be a factor for determining either hi power or low power. It should be transmitter power out. PERIOD! By using ERP you are forcing one who chooses to ru