I switch between both a headset and a boom mic using a foot switch. I made an angled foot rest for under my desk to help relieve leg and back fatigue during contests. I mounted my foot switch to this
Hi All, I "saved as" my SS SSB log as an ADIF file, no problem, I saw the other posts. The question I have is when I imported it into my regular logging program (HyperLog) , it could not read the sta
Was there ever a reply to this post??? Or did I miss it??? N5SMQ <<<<<I'm confused. The below message talks about upDATES and upGRADES.. <<<<<Are "updates" going to be still part of the cost of the b
I wish everyone would go back to my original post and re-read it.... All I asked is if Kent ever got any replys to his post..... I didn't ask to be berated or miss quoted. Sorry I even asked.... GEEZ
This may help me out in my problem too... When I created an ADIF file to import into HyperLog, the QTH was in a line called <ARRL Section> instead of a line called <STATE>. HyperLog looks for a line
HELP!!! I downloaded the recent upgrgade, divided it up on floppies, and took it to my log computer to install.... when I run Setup from the floppy to install the up grade I get an error that tells m
Ok Fellas, I have searched and scrounged my way to glory.(i think) I have gotten WL set up for CW, RTTY, PSK31, and SSB....... All memories set, screens set, played .wav files, sent digital signals a
I am sending this again, I got only one reply suggesting I check and see if my comm keying circuit works. As stated below it works with other programs. I sure could use some help on this. SMQ..... Ok
HMMMM This sounds similar to my problem that I asked about twice. Hope we can get an answer... My Comm Keyer won't PTT for RTTY or SSB... Works good with Digipan and PSK31 V1.03......SMQ I am trying